Creo Parametric - Creo Simulate - Force Loads (Part 1)

[@339lenny]

What is the difference between the pressure and force? Right now we use a surface as a reference for a force (p=F/A). Will the force be applied to the entire area? If I have a large sheet and a force in the middle the results are completely different because creo uses the resulting pressure over the entire surface?

[@patradebabrata123]

Please upload video on Weighted link between point load and any mounting bolts

[@SeanWebb]

Thanks!

[@BeWithWasif101]

Sir congratulation for 14k subs.

[@0500630]

Interesting video, which license would be needed to perform these actions (and the ones in the upcomming video)?

[@CADPLMGuy]

Creo Simulate

[@arunjyotiacoustic2450]

@@CADPLMGuy how to create a a point mass and connect to a geometry surface for doing modal analysis

[@karanrajm2019]

Thank you for the video sir

[@CADPLMGuy]

Thanks for watching!

[@BeWithWasif101]

Wish u 100k very soon

[@shanmugappriyans2614]

I can't able to Understand any vedio in this Creo ur teaching is not good

[@CADPLMGuy]

I encourage you to make videos with good teaching if mine are so bad.