Creo Parametric - Patterns - Dimension Patterns with Part-Level Relations

[@loboslobos14]

Fantastic information. Some times we just calculate to spread the features evenly on the base with a given dimension for x y y, but when it changes you need to modify the pattern. Thank you, excellent video.

[@CADPLMGuy]

Thanks, Raul. Often I do the same - calculate the increment and then plug in the value manually - when really I should take a couple minutes to figure out the Relation so I'm building Design Intent into my model.

[@diegogrunfeld]

Thank you so much Dave for sharing your own creations with us. This equation is really usefull. Your videos are so informative, you can explain Creo perfectly. Keep doing so!

[@CADPLMGuy]

Will do!

[@ananashrabiananno2474]

You are just amazing sir! Thank you for showing this example!

[@CADPLMGuy]

Glad you liked it!

[@meinkonto6344]

Thank you for this informative video.

[@CADPLMGuy]

Glad it was helpful!

[@mustafaaljweijati7663]

Is there a round function in Creo ?

[@CADPLMGuy]

Yes. You have ceil (ceiling) to round up and floor to round down.

[@muthukumar035]

Good information, I like to increment the value by constant ratio (non uniform gap) in direction or two incremental value in single direction is possible.

[@CADPLMGuy]

If you can write an equation, you can do it.

[@muthukumar035]

Creo Parametric , please any example