Creo Parametric - Global Interference Check | Analysis Tools

[@lustrouscyan]

Thanks so much as always, clear and to the point instructions.

[@CADPLMGuy]

Thanks for watching!

[@sportundkulturkollektivdre9819]

is ther any extra plug in, that allows to differenciate between any ordinary volume and a part with thread? from ptc help desk I got the answere, that Creo is not able to determine if a volume is an object or a threadded part that sits in a threadhole. If I do an Interference Check, all I want to see is screws not sitting correctly aligned in the drillhole. The funktion shown in your video is crutial for my everyday work. thanks for helping

[@jpm_6318]

Is there anyway to exclude skeleton parts from the interference checking?

[@CADPLMGuy]

Hmmm... I thought Skeletons were automatically excluded from interference checks. I don't create solid geometry in my Skeletons so it's never been an issue. But Simplified Reps with a Rule would be an easy way.

[@vanlinhto5160]

I just want to check to interference bettween 2 or 3 part in assembly Do you have a solution ??? Thank you very much

[@CADPLMGuy]

Simplified rep

[@jpm_6318]

Pairs clearance can check interference between two parts only.

[@eartheartbaratheon791]

@@CADPLMGuy Sounds good, doesn't work. Excluding items in simprep still results in full interference check picking them all up. Creo9. Perhaps there's some kind of a variable in options? Edit: It actually works...but not always. Ehh...troubleshooting, here we go again...

[@rameshdharman9197]

Thanks for uploading this video. could you please explain more about fastner selection (example: M3 screw and M3 nut ) because l am working on a assembly which has more than 1000 fastner, i got interference for the for this 1000 fastner too.

[@CADPLMGuy]

There are so many different factors involved, like where you got the fastener models from. I can't answer without knowing more about your setup. I am available for consulting. See my website for more information.

[@jakobmitchell1568]

"we have a lot of interference, there's 9 here" ... Me watching this with 355 interferences: 🤠

[@adrian6790]

How to remove interfering volume between a solid weld and a part?

[@evertonfortedasilveira5415]

Ola amigo ! Você pode fazer um tutorial de como fazer tubulação no Creo!??

[@CADPLMGuy]

eu já fiz

[@evertonfortedasilveira5415]

Pode me enviar o link?? Lhe agradeço muito pela atenção!

[@CADPLMGuy]

kzbin.info/www/bejne/o5LMlYajpJ5gi6c

[@trentoncarr]

I like this type of content. I got at least 2 WTF! I can do that?

[@CADPLMGuy]

Glad to hear that, Trenton!