I like your videos cuz u literally just get to the point and do it you dont sit for half the video talking you nailed it my man
@bacfab92592 жыл бұрын
I appreciate the feedback brotha thank you
@frankfurther38282 жыл бұрын
I'm glad to see you wearing all the gear.
@shanedevries8052 жыл бұрын
Well done mate , nice work 👍
@bacfab92592 жыл бұрын
Thank you brotha
@frankfurther38282 жыл бұрын
and sweet beads also
@rorikolson2 ай бұрын
One comment I've come across many times by guys who weld steel buildings is that (short circuit) mig is not approved for structural work. Structural being stick (or flux core). I think it depends on the settings and the gas used, as well as the technique of course. Just curious what your settings were and what gas you use. I have an idea of what I would set the welder to, over 23 volts, somewhere over 400 ipm. Gas would be 90/10 argon/co2, or 90/8/2% o2. If I could turn the frame sideways to do the sides I would go 26.5 or 27 volts, 550 ipm, and spray it together.
@IpsyProductions Жыл бұрын
Was the original driveshaft put back on or did it have to be replaced?
@bacfab9259 Жыл бұрын
Had to be made shorter and balanced at a driveline service shop
@FINfinFINfinFINfin5 ай бұрын
How ide was the scab plate? 6"? I missed where you made the template. Thanks
@christophergreen41157 ай бұрын
What size wire are you using ?
@bacfab92595 ай бұрын
.30
@jamestyndall5292 жыл бұрын
Why drill those holes out you have a plasma cutter?