Crown Vic Swap and Rear Axle Flip 1968 Ford F100

This is just a video of some of the pictures I had taken while doing this build. I wish i would have taken more pics and videos but this is what I got. Thanks for watching. If you have any questions just comment and ill try to help ya

[@SnailGs]

Enjoyed the vid👍 thanks.

[@RadFabz]

Thank you for watching!!

[@VAbow78]

Truck looks great, love the yellow and white

[@byrook010]

❤

[@byrook010]

Nice project, can you tell me what you did in the wire harness

[@RadFabz]

Thank you. And thanks for watching my video..I used the wiring harness from the crown Vic. I just labeled everything first,then layed it all out on the floor and kinda went thru it eliminating everything we wouldn't need,by cutting it out and taping it up.

[@als.6037]

How did the HVAC work out? Did you use the cab controls from donor?

[@byrook010]

Which wiring harness did you use

[@rickycortez6733]

Awesome build. How did you solve the differences in the lug pattern with the CV front end. I’m about to start the same thing. I think I might have to drill the rear axles to match

[@RadFabz]

I used some lug adapters from eBay so that the back would match the front.

[@outdoor831]

S0 front and rear are different wheel pattern?

[@israelfranco5332]

Great Vid! When you did the axel flip, did you have to cut the driveshaft?

[@RadFabz]

Thanks for watching. And no I didn't have to cut the drive shaft. Everything lined back up perfectly

[@israelfranco5332]

@@RadFabz thanks for the quick response.

[@AndreDrex]

Where did you buy the kit?

[@ozielmadrigal9374]

What set of shocks did you use in the rear?