day two of welder

[@L_E_L_0_U_P]

I thought Randy from trailer park boys had a welding channel now

[@tronclay]

Saw the belly and clicked the video hoping to see some cheeseburger confirmation.

[@michaelpurdy5908]

Came here to say this lmfao!!!!!!! 😂

[@mattsan70]

Gotta say that was the most painful 15mins of my adult life - If I was you, stick to JB Welding

[@Ca21431]

Next video- watch me weld the frame on my truck!! Lol

[@hunclex7495]

Well nobody made you watch to the end.😅 30 sec. Was enough for me.

[@gardencornrobber]

Put on a shirt! You're pushing a c cup.

[@billbudnic2941]

don't give this guy any sharp objects. first rule of welding. put on a shirt!

[@dagrimlin9392]

Maybe a drill and some pop rivets are more your speed.

[@K.P.Alexander]

Sincerely, I admire the fact that you're trying to learn a new skill. No shame in that whatsoever. But, PLEASE, watch a few videos on the basics, as well as safety.

[@delmaneboshoff5610]

Dude. Have you heard of this wonderful tool called a needle nose pliers???? Seriously. It would have worked very well in feeding that wire into the feed rail/tube.

[@mikehess8116]

Committing 2 sins in 2 separate trades. Sheet metal workers would chew you out for cutting wire with tin snips. Welders would wonder why the hell you don't have needle nose pliers or a welper. Wire speed in inches per minute. Gauges on the face of the are voltage & wire speed. Very very painful to watch. For the love of God, tighten the tip & push the nozzle on

[@danburch9989]

Expose filmed on location in Appalachia. The expose is his beer gut.

[@carbonfiberc0219]

Put that thing away bro😦

[@jimmanyk]

Is that spool of wire to big a diameter? looking at the feed angle. I'm fairly sure that "birds nest" will knot at some point, when you could do without it!

[@MrMrjwongy]

moobies

[@vdriverpgm]

Not a total waste - as good as Vaudeville slapstick comedy.

[@mazspeed003]

You got some serious issues dude...it literally takes 10 secs to do this....lmfao

[@joeprinsen1717]

naah bro. put that back in the shed and stick to masking tape. you clearly have no idea what ur doing...

[@ανακολ]

my god you don't have to do something like that, you're just embarrassing yourself, read first and try it out privately and then show it, your hands are shaking, the video is shaking, I think the video isn't the best so I'll write you a few tricks when you put in a new roll of flux wire, you have to know that flux doesn't need gas, but it's very expensive, so you take out about 1 meter of wire, so that you don't have the same problem and the wire comes loose, you tie a piece of rubber from a bicycle [inert tube] so when you have the 1 meter wire you put the rubber directly on the roll, don't put it in the machine, leave it outside, take the end of the wire and bend it straight because the wire is round, it has to be straight so that it doesn't scratch the inner channel so much, it has to run nicely inside now you can let the machine run a bit until about 80cm then you put the roll in, press a few times so that the wire is taut, now remove the rubber if you buy new wire don't be stingy with flux if you buy cheap wire it can splash, it depends on what you are welding

[@RoggerMed]

Lefty lucy/Righty tighty.