DC Audio (level 5) 12in unboxing and direct lead hookup

Sourced through Sky High Car Audio. Took a little over 2 months to get due to raw material shortage. They since put a price increase through (bit over 10%) and removed the SPL Neck upgrade and high roll Huge Surround Ground Pounder Cone from Sky Highs options.
Link to heat shrink (used the 24mm x 1m, cut to size):
1meter 4:1 heat shrink tube with Glue thermoretractile heat shrinkable tubing heat shrink tubing diameter 4 6 8 16 24 40 52 72 urldefense.com...
Splicer:
www.homedepot....

[@bluedemon7601]

Those splice connectors are game changers!

[@flawlessinc]

Beast subs painful clean and sq all in one but I went to the maximum on the box w 2.5!net and holy Cow they said no but I see why… Its doing hair tricks and doughnut rolls w Truck doors flapping Ram so… T What’s your thoughts I’m building a band pass atm..

[@JosephCee]

What's the RMS on this monster, 5000W?? 😱

[@ogscythe6118]

It’s rated 3500 but have it hooked up to a SMART5BASS TARAMPS at 1 ohm. Digs deep on the lows, down to 26hz. It’s a nice sub for sure. It’s in my daily still.

[@jaz97]

Damn that sub is legit 🔥

[@nycliving9514]

Brother can you link everything you bought to hook up the direct leads? Also, how many ohms is the sub?

[@ogscythe6118]

I added the splicer link picked up at HomeDepot. The woofer is a D2. The wire ferrules can be picked up from Sky High Car Audio.

[@Carlossteezyblunts]

hey there hows it going, just saw your high output alternator video and in that video you mentioned you needed a pcm to control the voltage looked for a follow up video o that couldnt find it. did you end up being abl t yass the volage conrl. i have a 07 accord and my voltages drops without the headlights on. wondered if the pcm worked for ou?

[@ogscythe6118]

Yes it did. I have a CES (Custom Electric Services). 240 and had to buy the GM setpoint regulator for PCM bypass. Had to put it on myself but it really wants a big deal. Bypassed the factory alt plug and spliced where I needed to…I regret not filming that but it was a two man project to film. customelectricservice.com/products/denso-type-gm-14-8v-set-point-regulator-for-pcm-bypass-or-replacement

[@Carlossteezyblunts]

@@ogscythe6118 Sorry a little confused. So the plug that goes into my alternator, i need to cut that plug and put this plug in its place, then plug in a vcm to the new plug?

[@ogscythe6118]

@@Carlossteezyblunts you do not cut it. It’s bypassed all together. You “add” new lines for it. Check out Jonathan Patrick’s page for some videos. He owns Brand X Electrical (sells HO alternators). Find him on FB. It’ll be a lot easier to follow on there than me explaining blindly on here.

[@Carlossteezyblunts]

@@ogscythe6118 ok will do thanks a lot

[@sermac3246]

👍