Debaffle Kawasaki Vulcan 1600 mean streak

[@steveneschleman672]

I just yanked mine out but didn’t like the echo sound so I unbolted pipe up farther on mine. So just ran the two short pipes from block. Louder than Harleys

[@nostopinLucR]

Awesome, saw your video and went out and did the same to mine, sounds much better now. More throaty and a little loader but not to much. Thanks for sharing.

[@bikersoncall]

Don't forget guys, your back pressure is going to be different, will probably need a fuel management module, my bike came with a Power Commander 3, I think they've been around for quite a few years, probably lots of other modules out there.

[@misplacedcaper9662]

Not necessary. You will need an FMM if you change both the exhaust and air intake though. You can run a full aftermarket exhaust without the module. In this case, the "goat belly" exhaust is still intact, so he's only adding a couple of decibels by removing the silencers.

[@bikersoncall]

I like the plug feature, then drill , otherwise you'll get scratches , gouges and nicks, all over the place. Mine was already done when I got it, Cobra longs I think, I don't think they were drilled out, I think there was a different type of mounting.

[@gimmieliberty6514]

When you cut or drill use lubrication,wd40 will do,that screeching is the cutting surface getting so hot it melts and welds,lube stops this,when it screams again,lube again

[@AnthonyKefo]

Could've done without that noise tho. 😒

[@TKO-NY]

Yea, needs to omit the catalyst system and run straight pipes. You're right. Good call!

[@draxthedestroyer1685]

Could a beginner such as myself that has been riding a ninja 250 for about 2 months ride this without any issues as far as experience goes?

[@patriciopalmasolis]

there's no changes at all

[@steveneschleman672]

Yes. Absolutely. My first bike was a 2008 Kawasaki 1600 Mean Streak. I ain’t right in the head either though. 🤪

[@lestertechnologies8914]

Hi Patricio, i have the 2007 special edition, quick question after removing the baffles, did you experience loosing some power on the bike?

[@patriciopalmasolis]

Lester Technologies not at all, there is a catalist chamber or something in the middle of exhaust system, this chamber hold the motor noise

[@patriciopalmasolis]

goo.gl/photos/oRzhqeJiv9YgSmub7

[@wildlifelive06]

what size hole saw did you use?

[@patriciopalmasolis]

+jeremy pickett www.bricolajeparaprincipiantes.es/upload/Image/Boren-in-steen-of-glas-03.png 1.5 inches

[@TKO-NY]

To the ear, was the noise difference enough to be worth bothering with? I've got one up for sale, and if it would give it an aftermarket sound, I'd do it quick I suppose. Thx.

[@wildlifelive06]

@@TKO-NY it's well worth doing. Big sound difference.