Deepcool AN600 Review vs AXP120-X67

[@Wendriel]

Thanks for this test, I'm pretty impressed seeing it maintain the boost clock without thermal throttle. Currently deciding between this cooler and the NH-L12s

[@CarlosHenrique-ug6rw]

Opa tudo bem ? Canal top ja me inscrevi ok Te perguntar... esse AN600 e compativel com Memoria Ram 48mm ? Caso venha inverter o lado dos heat pipes ?

[@vadzimshynkarchuk939]

Thank you for the video. Very helpful. It would be interesting to know what the results would be if you replace the cooler with a Noctua NF-A12x15 and Cooler Master Mobius 120 OC ?

[@DalraeMyo]

If you replace it with a high-performance cooling fan, I think the temperature of the CPU will be lower. Unfortunately, we have changed the system to Ryzen system to prepare for the next video, so additional tests will be difficult.

[@KuntalGhosh]

😮180w and still below 100c. Is quite an achievement. Try it with the 13900k.

[@FerSniper]

Лучший, спасибо за потраченное время!!!

[@exx1st3nz]

top music choice!

[@tt7crocodiles]

Thank you! Very helpful for me

[@claudej8805]

I use a similar cooler. I did close the gap without fins under the fan with cardboard and found it to improve the performance.

[@DalraeMyo]

You did an interesting test. I'll keep that in mind. Thank you for the good tip.

[@claudej8805]

@@DalraeMyo (I did go all around with the cardboard to achieve an even layer)

[@claudej8805]

@@DalraeMyo If you try it and find no difference in temperature. It might be because I use the fan upside down. In my case the cooler lies directly under the psu, hot air from the cpu is exhausted straight through the psu.

[@smuludgn]

​@@claudej8805your case is SG13?

[@claudej8805]

@@smuludgnNo, I have the SG04B-H

[@achiramoto359]

What about the Noise - its very importnat in sff builds...

[@victorhenostroza1871]

Try with ryzen 7950x please

[@esk99l32]

팬 소음은 어떻게 비교 되는지 궁굼하네요. 녹투아 120x15를 사용해도 AN600 성능이 우수할까요?

[@DalraeMyo]

TL-C12015보다 아주 살짝 더큰느낌입니다. 개인적으로 녹투아 a12x15를 쓰면 다운그레이드가 되지 않을까 싶습니다.

[@BonelessBBQ]

AXP120-X67는 저번 영상을 보니 전원부 방열판 쪽과 간섭이 있어서 약간 휘어서 장착을 하셨었는데 이 제품은 아주 작은 오차로 간신히 장착은 되는 거로 보이네요. 아니면 메인보드 차이일까요?

[@DalraeMyo]

말씀하신대로 AXP120-X67은 보드 전원부 방열판의 모양에 따라 전원부쪽으로 장착시 살짝 떠서 장착이 됩니다. AN600의 경우 AXP120보다는 살짝 간섭이 덜한느낌이었습니다.

[@fractera]

You're testing this wrong. Put it inside an ITX case because that's where these coolers belong. I expect temps to run hotter.

[@DalraeMyo]

Yes, that’s right. If you actually put it in a PC case and test it, you'll get different results. However, I have decided to use an open bench system because I cannot prepare both PC cases and CPU coolers of different sizes every time.

[@smuludgn]

​@@DalraeMyoYour method is much better imao. Cause every case is different at least we have an idea to compare cooling performance with each other.

[@SanjaySingh-hb2zs]

Thank bro make this video. 😊

[@0ninetwo]

Wi-Fi antenna looks gorgeous. Link or name?

[@DalraeMyo]

You can find it by searching 'FPV MINI ANTENNA.'

[@0ninetwo]

@@DalraeMyo thank you. Much Love from southern most tip of India.

[@tonyjaa8314]

Class) I noticed that I worked without gloves as usual)))

[@volosol]

Hello. I have a 12400f processor. ASUS PRIME B760M-K motherboard. Can I use AH600 for this configuration. I only play games and have not overclocked them.

[@DalraeMyo]

CPU cooler with enough performance to cool the 12400F.

[@InfoEletroGames64]

Test in games?

[@ted-b]

Pretty good for a small cooler.

[@WatermelonSaurus]

녹투아 L12S와 An600을 비교하면 무엇을 더 추천하시나요?

[@DalraeMyo]

사용할 케이스에 맞춰 선택하시면 될 거 같습니다. L12S의 경우 냉각 성능 자체는 살짝 아래지만, 딱 맞는 케이스에 사용 시 풍절음에서 좀 더 자유롭다는 이 점이 있습니다.

[@argmarius]

Do you think I can fit this cooler on b650e-i strix with the heatpipes on the RAM side? I have Trident Z5 RAM ( over 40mm tall).

[@DalraeMyo]

If the CPU cooler radiator is placed toward RAM, the maximum height of RAM can be mounted up to 40 mm.

[@DalraeMyo]

FYI, TRIDENT Z5 has a height of 44mm.

[@argmarius]

@@DalraeMyo i know that. I just wonder if i can place it reversed (to hang over IO) instead of ram

[@DalraeMyo]

Oh, I got the question wrong. I don't think there will be a big problem if it is placed toward VRM. I also placed it toward VRM, and there was no memory height limit.@@argmarius

[@argmarius]

@@DalraeMyo nice. I wasn't inspired when i did my switch to sff and got Trident Z5 instead of some low profile sticks, orherwise i would've used the Noctua L12 Ghost Edition with a NF 12X15 instead of the stock 92mm fan. So I'm selling the noctua and get a deepcool an600 one of these days.

[@sgnlup4984]

잘 봤습니다. 탑다운형 쿨러 구매해볼까 고민하던 차에 마침 영상이 올라와주네요. 근데 혹시 비교 그래프에서 각 그래프마다 색을 좀 다르게 나타내주시면 안될까요? 다들 색이 비슷하다보니 모바일로는 한 눈에 들어오지가 않습니다…

[@DalraeMyo]

피드백 감사합니다. 다음영상 제작시 참고하겠습니다.

[@sayohatga]

Hi my friend. Is it ok for AMD 7 3800XT? Thanks for your reply

[@DalraeMyo]

Unfortunately, I've never used 3800XT before, so it's ambiguous to answer exactly.

[@knightcore4062]

How would deepcool ag 500 perform against ryzen 5 5600 (non X) version...?

[@DalraeMyo]

I expect it to show a sufficiently pleasant temperature.

[@kuzzzzzzzzzzzz7511]

What can you recommend low profile cooler for 7800x3d?

[@DalraeMyo]

If you choose a product less than 70mm, I recommend three models. 1. Thermalright AXP12-X67 2. DEEPCOOL AN600 3. ID-COOLING IS-67-XT

[@kuzzzzzzzzzzzz7511]

@@DalraeMyo what is the best three of them?? No compromise for 7800x3d?

[@DalraeMyo]

The cooling performance is all similar. There are some differences in compatibility, and the IS67XT was the best one to use for ITX motherboards. I've tested 79X3D, but I've never tested 78X3D myself, so I don't know what it's like.@@kuzzzzzzzzzzzz7511

[@blindman8093]

wow this cooler an600 is amazing

[@blindman8093]

i hope you also try this in amd 7000 series

[@edzel14k]

phanteks T30 fan replacement, could it make it lower more the temp?

[@DalraeMyo]

If we change the cooling fan to a model with higher performance, I think we can lower the CPU temperature.

[@edzel14k]

@@DalraeMyo got one of this and test it with T30 with Ryzen 9 3900x. current CPU setup 1.2v 4000mhz with stock fan(for baseline) Benchmark with Cinebench Max Temp 81c CPU power pkg 118w Rendering score at 18116 (10mins) - With T30 Fan stock replacement Max temp is 74.5c CPU power pkg 118w rendering score at 18129 (10mins) - close at rendering both stock and T30, i just like the temp with t30 fan it lowers about 6.5c.

[@sobangcha3042]

@@edzel14k how is it when just gaming?

[@TurboD16z6]

So does it clear the ram if you flip it the other way?????????

[@DalraeMyo]

If the end of the heat pipe is installed facing the RAM, the maximum mountable memory height is 40mm. (I'm using more than 40mm of RAM, so it was impossible to mount.)

[@kseniarezumova]

Hello. Can I install this cooler on msi mpg b760i wifi. RAM height 44mm

[@DalraeMyo]

There is no memory height limit when the CPU cooler heatsink is oriented toward the VRM.

[@srijitsarkar7168]

HOW IS DEEPCOOL AG 500 FOR I5 13600K?

[@DalraeMyo]

Cooling performance may be insufficient if used in the default condition. You will need to use the undervolting or power limit function.

[@srijitsarkar7168]

THANKS FOR THE REPLY BRO, SO IF I SAY BETWEEN AG 500, AK 500 AND AG 620 'NOT AK' WHICH WOULD BE MOST APPROPRIATE HERE FOR I5 13600K.

[@parakek390]

can you turn off the led and what height does it support?

[@DalraeMyo]

The LED of the cooling fan is fixed in white and cannot be turned off separately. The height of the CPU cooler is designed to be 67mm.

[@parakek390]

@@DalraeMyo thanks for reply but i meant height as in ram-motherboard coverage (depending of orientation). at 02:46 you put it over the motherboard and i think it looks something like 45mm or so from my estimation.

[@DalraeMyo]

If the thickness of the memory heatsink is not thick, there will be no height limit. If there is any interference in the fan bracket, I expect there will be a height limit of about 45mm as you mentioned. (I don't have AN600 at this time, so I can't test it. Sorry.)@@parakek390

[@neumann896]

Compare with is67xt, what have better performance

[@leanduy]

AN600 >AXP X67 > IS 67 XT > HD6200D

[@neumann896]

@@leanduy thấy ngta review build quality của con is 67 xt tốt hơn an600, đắn đo quá

[@leanduy]

@@neumann896 đã dứt axp120 x67 :v

[@leanduy]

@@neumann896 lấy con bắt ốc như an600 hoặc is67 xt ok á, cái bắt gông nó lỏng lẻo khó chịu vl ra

[@young-j731]

Can you test the Pure lp please

[@DalraeMyo]

If I have a chance, I'll make a video!

[@nouryy]

Decent cooler!

[@RickFord01]

😮

[@_pant0m]

they should add more fins like 3 or 5 more

[@claudej8805]

You can't say this, you don't have all the parameters. Besides, I did close that area with cardboard on my similar cooler. I believe it improves performance.

[@giopagtalunan8762]

Whats your mobo?

[@DalraeMyo]

MSI MEG Z690i Unify model.

[@roman9509]

They look identical to me...

[@almightyura]

This testbench sucks. This kind of cooler needs a RAM with low heatsinks or no heatsinks. Then the overhanging part of the cooler can cool the RAM as well. A mobo with low heatsinks would also allow for better airflow. This one looks like a box in which this cooler just can't breathe.

[@josemiguel3043]

You have placed both the heatsink and the fan upside down.

[@NoneofyourBusiness-gy9yw]

made in china vs made in taiwan…. ill take taiwan

[@AshinaKhagan]

this doesnt fit my mobo🫡🔫