Excellent video very sort logic for all four conveyor thanks
@plcgoods3 жыл бұрын
Glad you liked it, and thanks for checking out the channel!
@puranmal32 Жыл бұрын
very helpful
@plcgoods Жыл бұрын
Glad to hear that
@ahmadkhaldi7705 Жыл бұрын
thanks a lot
@plcgoods Жыл бұрын
You are most welcome!
@digipeso Жыл бұрын
Maravilhoso vídeo
@plcgoods Жыл бұрын
Thanks, glad the content was useful for you!
@ayhamshbat27333 жыл бұрын
Pretty nice these instructions save alot of program lines, btw I have a question in my mind since u first vid , I noticed u don't use memorized coil to start an output like we learned at university
@plcgoodsmentor92233 жыл бұрын
Hi there, thanks for watching our videos. If you mean Set and Reset instructions, they have been used during some videos. however, a PLC program can be written in different ways.
@ayhamshbat27333 жыл бұрын
@@plcgoodsmentor9223 thx u for ur reply but I meant using M address coil instead of yo coil example
@plcgoodsmentor92233 жыл бұрын
@@ayhamshbat2733, I usually used Y coil, because I wanted to use my LEDs to show my program result. Naturally, M coils are used to store conditions on the PLC memory, not to turn on digital devices like LEDs.
@ayhamshbat27333 жыл бұрын
@@plcgoodsmentor9223 I meant to turn on output y by m coil
@plcgoodsmentor92233 жыл бұрын
@@ayhamshbat2733 OK. During the delta course, M coils are used to turn on Y coils too. for example, check out this link (kzbin.info/www/bejne/i6HYY2ulmN2Whq8) or this one (kzbin.info/www/bejne/aqCnq4qilplgr6c)