Going from a 2.7 to a 3.5, there was no modifications needed? everything was just straight drop in and go?
@JamesBrown-n9w10 ай бұрын
My 09 2.7 doesn't have blade runners, just not sure if that's an issue
@TheMorumotto Жыл бұрын
Did the same and pretty happy.
@clidee111 ай бұрын
question....im doing a similar swap 2.7 to 3.5....after puting everything back togther....everything seemed ok when i turned the key then i lost power in the inside of the car...now everytime i plug in the car battery it sparks/arks and it burns up all my small Ground wires....my grounds glow fire red when i plug the battery up and im pretty shore all grounds are connected...i have no idea what could be causing this......having a very hard time with this swap.
@wrld954010 ай бұрын
did you ever find the reason?
@cris16898 ай бұрын
Did u use the harness for the 3.5 or the 2.7
@ALAH319839 ай бұрын
Had a question, there were three transmissions that came with that 3.5 engine setup, it was the 4 speed, the 5 speed and the all-wheel drive. My question is I have the four-speed transmission, and the junkyard has the 3.5 L that was hooked up to a all-wheel drive vehicle. Do I just need to change the oil pan and flywheel or is the bellhousing area where the transmission bolts up different? Thank you
@cris16898 ай бұрын
What are you wanting to bolt the 3.5l up too
@CainFid8 ай бұрын
Was this successful...just engine needed?
@lizard59575 ай бұрын
Hello doing the same thing, I'm glad to have found your video. My 2.7l's 8th digit is d, so what 8th digit will i be looking for in the compatible 3.5l?
@chantelrhine89656 ай бұрын
Those aren't headers lol it's exhaust manifold
@NeoIsrafil Жыл бұрын
If youre gonna swap it...why not just go v8? The ECM has the code for everything up to the big 6 liter v8s... and if youve got the nag1 its interchangable across a ton of stuff. You just tell the pcu the engine is that liter verson. Its on...i think...( if youre gonna use hptuners) i think it was the general tab towards the...top left, youll find it east. I could go into hptuners vcm software and just swap that field to 6.1 and itd think it has a 6.1 and could run one just fine.
@DeltasWorld11 ай бұрын
Cheap option. V8 cost 5x the cost compared to just swapping to new v6 and gain 60 to 70 hps
@JohnGarcia-dx4gg8 ай бұрын
So did you guys use the same Harness the 2.7 had or did u get the engine with the harness?
@El_3ce6 ай бұрын
@@DeltasWorld i got a question im about to do the same thing but how can i check and verify the engine and the transmission numbers? Like u mentioned ?
@sethdunn965 ай бұрын
I am looking to swap my 2.7 in my 08 charger. The front end (bumper and stuff) is pretty easy to take off?
@chantelrhine89656 ай бұрын
All you had to do was pull the hood fans and radiator no need for the numper
@sethdunn965 ай бұрын
aside from the hoist, any other special tools for this job?