Design and Simulation of Push Pull Converter using MATLAB | SIMULINK

[@ElectronicsMaddy]

If you have any queries please drop your questions below.

[@sethuramans1118]

How to calculate the magnetizing inductance and resistance of the transformer?

[@bhaveshnagar9883]

how do you assume the values of various parameters like resistors, inductor, transformers etc.

[@ElectronicsMaddy]

It totally starts from the requirement. Like what Is your load and how much you want the output to be. Based on these you can decide

[@vishalpandule5585]

sir, inductance calculations are not matching.

[@aravind7730]

How to simulate an isolated push pull boost converter

[@omkarkulkarni6631]

Can you give the link to download your saved file(of this sim)?

[@poojalakshmi7242]

Very nice explanation 👌👌

[@ElectronicsMaddy]

Thank you

[@raghumaladeshpande1180]

Very clear and fantastic 👌

[@ElectronicsMaddy]

Thank you please keep supporting :)

[@الفارسالمغوار-ح3ث]

During the operation of switche one or two, the current in the inductance will increase and there is no discharge mode. you need to add a third state where both switches are off.

[@bhogeshdeshpande1693]

Awesome 👌👌👌👌👌

[@ElectronicsMaddy]

Thank you

[@bismazaffarele0278]

but why dont we mention the negative sign of C nd L? ....also what it mean when C or L are negative about converter?

[@tindyoprasetyo5001]

very good sir

[@ElectronicsMaddy]

Thank you

[@alagarkrishna96]

Please send me design of 48v to 12v 10amps push pull converter using sg3525

[@ElectronicsMaddy]

Hi Alagar Krishna. I want you to try it first and in case you are stuck then Mail me with the details to [e-mail]. I would expect you to brief your efforts and where you are stuck at and what is the objective of the circuit etc.

[@AkashGupta-zt3wm]

Show this simulation by taking one more duration when both switches are off