Development Junction flat pattern in Solidworks Sheet Metal

[@miguelmoreno6865]

Lo mejor con diferencia que he visto en KZbin. Muchas gracias porque el mundo hispano pese a sus 600.000.000 hispanohablantes apenas hay gente cualificada y generosa como es tu caso. Hay mucha gente pobre que necesita y quiere aprender y no puede.

[@Mr.Snow12]

If you are reading this comment please reply. Can you tell me when I flatten my pipe and export the cope file to dxf, the measurement is not correct. The pipe in real life is bigger than my cope template by about half inch. What setting would I need to change in solidworks to get the same size template that would work on a real pipe of the same size

[@kishorpanja7347]

Sir. Thanks for your valuable post on youtube.I want to know, how rotary air lock main body joint development will done in solid works.

[@macelwilliams6961]

I appreciate your work

[@shrikantmutthe1105]

Is it applicable for other than 45° angle?

[@mihaibr206da]

yes.you cam make this for any angle.

[@skarestars9905]

muito bom , gostei vou aproveitar bastante suas aulas obrigado!

[@macelwilliams6961]

can you develop a cone with a 90 pipe intersection and pipe with square pipe intersection as well as a square pipe with a round pipe intersection please

[@CALearnings]

kzbin.info/www/bejne/qmO1cqqGramAm5Y

[@mkindustries7815]

good work

[@rayannsun1553]

thanks! very helpful!

[@detodounpoco-un1il]

with conical please same 45 degrees

[@erdemcakr4636]

intersections are not perfect