Before I swap burrs, I wanted to video the stock alignment of these burrs. Sorry about the auto focus, these burrs for whatever reason don't video/photograph very well. www.turingrind...
Пікірлер: 17
@Coffeenerdtools Жыл бұрын
Incredible alignment.
@brandonrohrer2245 Жыл бұрын
Thank you for doing this! Can’t wait for the MP
@portakeeper Жыл бұрын
Been playing with the MP a little bit. It’s nice for sure. I need some different beans for it though.
@MillersMotors Жыл бұрын
Was watching with captions on, it says “ that’s the best Hawaiian burger I’ve seen” when you said best aligned burrs I’ve seen 🤣
@portakeeper Жыл бұрын
Hilarious!
@JoseRodriguez-wg9ei Жыл бұрын
I just watched the whole video just for that. Didnt dissapoint. Lol
@MillersMotors Жыл бұрын
@@JoseRodriguez-wg9ei it needed a cut to Jules eating a burger in Pulp Fiction 😆
@nar20862 ай бұрын
Does Dlc burrs grind for espresso?
@portakeeper2 ай бұрын
Both dlc and stock espresso burrs technically the same but the dlc has a coating on them to reduce friction
@geraldl5221 Жыл бұрын
Nice video, would you happen to be doing a burr alignment for the DF83? Is it the same as the DF64? Thanks for the videos!
@portakeeper Жыл бұрын
Same, BUT I have a video. Think it’s on the 64 but is much more detailed. Check out my channel.
@gokhangokalp99154 ай бұрын
Hi, I'm experiencing some issue with zeroing/alignement with my dlc burr. Once i zero it and grind something coarser around 60-70, then I can't get it back to finer. After that grind, new zero is becoming around 50 and hearing noises. Have you experienced something like that?
@portakeeper4 ай бұрын
Unfortunately not really sure what is going on
@horriefic11 ай бұрын
My DF64V is inconsistent. Eg. with everything equal, one shot can take 35 secs, and another 25 secs. Could it be my burrs are not aligned?
@portakeeper11 ай бұрын
not sure, I doubt its the grinder or alignment. 99% of the time when I hear this its puck prep. Have received returned grinders that were "inconsistent" and I can pull 10 shots back to back and all the same. Might do WDT. if you are using something like a lever machine, that adds even more complexities.
@bha4912 Жыл бұрын
Just curious, how you clean the grinder after completing the alignment? Won’t the marker be poisonous?
@portakeeper Жыл бұрын
Marker is not poisonous. Quick cleaning brush and run a few beans through. Good to go