Diagnose & Fixed JS220 Engine won’t start problem .

[@ajharulislam8658]

Good job sir, you can wish new video everyday. And I am everyday see your video. I am mecanik from bangladesh

[@arifariwibowo5869]

Thanks for all the information that has been given about the jcb unit. i still need to learn a lot about jcb engine

[@awakenwolf]

Hello Mr. Zaw Min, could you please help me on this. I have a 2012 JCB JS220LC, it has Isuzu 4HK1 engine, while operating the JCB excavator the engine suddenly stopped while working. It won't start in normal mode (although it cranks ok). It can be started only with limp mode switch turned on. The dash panel shows no error message, and no check engine light. Is this something you can help me with? Thank you very much if you could get back to me.

[@Dexter-o5i]

Sir how about , I already replace injectors but the machine still no start ? Thank you

[@jalelsaidi3827]

Plzz how we can do the test of the high pressure alone ?

[@jenisdauletov1606]

Hi Mr Zaw Min I show Ur channel every time Ur video is good 👍 Can U help me? I have a JCB JS200W Wheeled Excavator Engine won't start! In EMS shows Fault Code - 143 GLW PLG! Then I checked In JCB 4 Servicemaster shows a /Machine Fault Codes/ ECU1 - Active Fault Codes/ 143 Glow Plug Relay open circuit/Comments- Check relay & wiring/Then I checked All Preheat Glow Plugs from engine - it was OK! After that checked Glow Plugs Pre Heat Relay - it was too OK! Maybe on Machine side have another Glow Plug Relay? I don't understand What does it mean)? Can U help me Thank U very much

[@hansconhye2091]

Is your starter swing. Pls check main fuse . Have one for Glow and starter. While cranking voltage go to starter ang glow plugs. I got same promblem on js 200.

[@jalelsaidi3827]

@@hansconhye2091 what do you means by the starter swing plzzz ?