diagnosing and fixing a failing injector 2012 maxxforce dt

not the greatest explanation but a general over view of the process and procedure

[@user-vm6gs6rn5i]

Disculpe tengo un motor igual pero perdio fuerza y lo apagas y le mueves unos arneces que van en la manguera del posenfriador

[@tims.5339]

Im not sure exactly what you said because the translation isnt very clear, but if youre saying that it loses power and after moving that harness it comes back, it sounds like you may have a bad wire somewhere in that harness, or a poor connection to one of the sensors, if that is the case, try moving those wires a bit with the engine running, see if it changes anything, and if it does try to pin point exactly which wire is the cause. If thats not the case, and your losing power, i would start by checking all the intercooler/turbo plumbing, make sure nothing is torn or loose, sometimes the clamps like to snap, also the bottom of the plastic air box where the air filter is tend to crack, if thats not the case, check your fuel filter and the housing, and also the fuel screen which is located next to the filter housing, make sure everything is clean, the housings tend to get gunked up, you can investigate further by checking your icp sensor, and the ipr valve, then run injector test and make sure everything is functioning properly.

[@susanmueller1819]

🌈 *Promo sm*