Generator fail to start | diesel generator Common problems | crank fail | Fail to stop

[@Mechanics_world007]

Thank you for sharing your experience about gen set troubleshooting my dear friend

[@DieselGeneratortraining]

Ur welcome

[@mesumbearmstrong1301]

Thanks very much,i wish this teaching should go with a video sir,so can know the relay and fuses controlling the solenoid

[@GiftSilaseze]

i have follow you for a good time what i need is certification to show that i have attended your training , thank you

[@MollaAlem-s8y]

Model 1506A perkins generator 250 kva there is also ECU crank but not starting what the problem?

[@exclusivesafar]

Good job 👍

[@nalkamannalkaman4937]

Super explained sir thq

[@DieselGeneratortraining]

Thanks

[@honoratojrogoc4535]

Thank you my friend watching from isarael

[@DieselGeneratortraining]

Thank you too

[@-wheeling9509]

Thanks brother

[@m.habdullah8052]

Thanks 👍

[@mandaragat3395]

Thank you my friend...

[@DieselGeneratortraining]

Ur welcome

[@magisamarcy1012]

That's my problem my friend i hope you give some tips for me to fix my problem thanks

[@teehashashth]

I had 6010 controller with fail to stop alarm . I change 3 vdo10 bar oil pressure sensor but still the same condition... suddenly it fail to stop gone and then I can run it. After 5 second again stop and show stopping and cannot be reset . After timer goes out I had fail to stop again .... what shall I do?

[@Mohamadmouatasim90]

Thank you very much 🥰 Why "failed to stop " is related to oil pressure sensor instead of the Solenoid,?

[@DieselGeneratortraining]

Great point!

[@alastairwaters9114]

Majority of generator controllers use the oil pressure switch to detect if engine is running, so if you have faulty oil pressure switch then the controller might expect to see that switch open when we shut off engine but if its closed then the controller is still thinking that engine is running. Simple

[@zahidhassan3314]

Sir pcc module ki viedo banye

[@kishorkumarbaroriya5459]

Hi, if engine failed to start so more chaces of MPU not sence the RPM and air trapped in fuel.

[@DieselGeneratortraining]

Many aspects

[@hayleyesuskassa6473]

How to check fuel relay fuel selonoid practically ?

[@FrederickNuqui-s4x]

Mebay 25kva sir they change after that start is o.k but a few second will off.what is the problem sir thanks

[@magisamarcy1012]

Actuator not working that's why engine fail to start connection is not normally works

[@gibsmhel5579]

Sir i have problem my generator start to fail then i direct the solinoid it its running i change the realy then start running not also running

[@DieselGeneratortraining]

U need expert inspection

[@beleteabiye6203]

THE generator show governer alar it is not startes when i make start will near to start and then will stop, what i will do?

[@DieselGeneratortraining]

What is the model of Generators

[@NkosinathiNotununu]

Hi sir , what happens if the generator is starting via a relay and through a direct wire but does not run on its own it requires one to hold accelerator and once you let go of the accelerator it then switch itself off. I also get the fail to stop alarm. The generator doesn't not start via the control panel. . Where should I start checking? Thank you

[@muflihmuslih9979]

Sir our Smartgen operating or ranking start fiw time quickly buzzer alarm coming & outermatic generator stop how check sir i need instructions thanks

[@mauriceamollo8237]

While changing oil filter,is a must to fill it with oil before installation just like fuel filters?

[@muhammadjunaid9332]

Dear sir,In emergency how we can bypass oil pressure sensor..

[@alastairwaters9114]

You shouldn't have to by pass it? Depends what controller you have but when cranking remove the oil switch wire and that should by pass it but you shouldn't bypass it unless you want to see metal lol

[@sarathiv.s4192]

Failed to start, low oil pressure light indicated

[@dipupandit4156]

your dg why dish pley sow the. run feedback fail. please really caterpillar have DG. 500 kV

[@DieselGeneratortraining]

Which engine C18 and which controller type

[@aliaditv4122]

Sir guidelines chaiye

[@DieselGeneratortraining]

Send your inquires on [e-mail]

[@kewalsingh9934]

pls make in ATS foult video

[@DieselGeneratortraining]

Ok noted always comment what u want to learn about

[@malikshahid4859]

😅😅😅😅😅

[@DieselGeneratortraining]

😁😁😁😁😁