Dillon RL1100 - Seating and Taper crimp Dies - Running the Press

[@chuckcullup1384]

I just started using the full set of Mighty Armory dies for 9mm on a Dillon 1050 super. I love the new dies

[@thescbaron]

Loading 9mm with a MA sizing die is on a whole other level, so glad I made the investment. Side note the MA sizing die really lets you know if a 380 got in there.

[@bjagfan9452]

Thanks for the series, always interesting. I used your series to setup my T7 on 10mm/.40S&W. Leaning towards the 550 to setup the 9mm. I will be checking out the mighty armory dies for it.

[@X_USSR_Soldier]

Thank you. Definitely want to learn more about RL1100. Good lessons!

[@mesmerize2o9]

I use their 9mm sizing dies and their universal decapping dies

[@gerseo1375]

Thanks, lots of useful information.

[@jsimpson8018]

I am VERY happy to see these videos. I had issues with some plated bullets and not holding a crimp. they fit in the case gage great and no issues there, but the bullet would become loose and spin in the case. Aside from not using plated bullets, what advice do you have.

[@SquatchReloaded]

The Dillon powder funnel used with the ID hold down mandrel is a no go. I opted for the universal powder funnel that does not have an ID mandrel and it eliminates what you are describing.

[@jsimpson8018]

Link for the funnel?@@SquatchReloaded

[@plow9133]

I notice from other videos your not a fan of seating dies with a roll crimp not that you need it on the 1100, I have started using them more here lately with the 750, i can still use my Mr bullet feeder with a powder check, was very cautious at first , started with 223 and like it and now use it with pistol but I do love your videos

[@SquatchReloaded]

Thanks for watching. It’s true combo dies and powder checks I am not a fan of but I am glad you found a process you are successful with.

[@michaeld3230]

What camera and monitor is that? I have been looking to do the same thing but I have 12 automated presses to cover so cost is a bit of a concern. I would also like to add a camera to my case and bullet feeders.

[@SquatchReloaded]

It’s a Oiiwak borescope

[@michaeld3230]

@@SquatchReloaded thank you sir!

[@connormarek1028]

Did you say 0.005 or 0.0005? That is pretty consistent either way.

[@derekfrench5293]

What mount did you use to affix that camera to the press? Do you also have a link to that?

[@SquatchReloaded]

It is a RAM cell phone mount

[@glenrubottom3009]

I noticed you have the Inline fab micro mount on your 1100. just curious what is the height of your bench, mine is 38 inches and I was surprised how much nicer my 650 was when I went to the ultra mount 9" over the Jr 7", I'm 6 ft

[@SquatchReloaded]

My benches are 33 inch’s if I remember correctly