Ditch Assist cuts too deep! Easy Fix

[@jilleesageorge4344]

Sutton says you’re doing a good job! 🎉

[@AxiomAcres]

@@jilleesageorge4344 tell him I appreciate it

[@wayneinnc5379]

You have a talent! As farmers do! Engineering at its best!

[@AxiomAcres]

@@wayneinnc5379 lol. I knew my petroleum engineer degree that’s collecting dust would come in handy around the farm. Lol

[@Hanorob]

Nudge your Ditch Assist up and start cutting that way. Then Nudge it down as you go. That way your controller is not trying to take the whole cut at once.

[@AxiomAcres]

@@Hanorob still happens even if I do that. If the clay is hard it’ll glide on top instead of cutting and then the ditch assist thinks it needs to go deeper so it tries to but the tires just come further off the ground, until you hit a soft spot and then there’s nothing limiting the blade depth. Then it suddenly cuts 10”

[@AxiomAcres]

I always nudge it so that 2” is my max cut

[@Hanorob]

@@AxiomAcres Right, I see what you are saying. I don`t have the valve, just run it manually. Had not occurred to me, that it would keep raising the wheels.

[@AxiomAcres]

@Hanorob didn’t occur to me either, until the first time I used it and created a massive speed bump in the middle of my water run