DIY 2017 - 2018 Toyota Corolla Front Bumper Removal / Takeout - Any Bumper Takeout

[@eduardocornejo2903]

Helpful video. I couldn’t figure how to take the last connection off. If I’m going to force something off I want to make sure I’m taking it off correctly

[@AngelMorales-kl2vi]

Hi. Great video! I have a question though. At 3:45, the harness that splits into the radar has another split going into something mounted on that support. Do you know what that is?

[@Jasonttime]

Hello! Thanks for the video. It is great! Four questions: 1) do you have the part numbers for all the clips you removed in the video? I asked the dealership, but they are not providing any help and told me to get the part numbers. 2) When you pop the corners out at 2:45, do I need to replace any of the clips inside? 3) Also at 2:45 when you remove the corner, will this process damage the bumper side of the clip? I would like to do some repair and reuse the bumper. 4) To install the bumper back, I assume to do the reverse what you did in the video? Thanks for your help! Again, great video!

[@HowItsFixed]

Hi Jason, 1) do you have the part numbers for all the clips you removed in the video? - Honestly the only clip part numbers I know is 5387958010 and 4774958010. They come on the corners of the bumper. If you have the same car, just give your VIN number to the dealer and ask them to send you the diagram of the front bumper with all the part numbers. They usually send it through email. You will figure the part # for the clips there. 2) When you pop the corners out at 2:45, do I need to replace any of the clips inside? - It Depends, if you take them out properly then you don't really need to replace any clips. If you are doing it for the first time, I would recommend doing it very carefully 3) Also at 2:45 when you remove the corner, will this process damage the bumper side of the clip? - Not really. Again it depends if you takeout carefully then it should not be damaging anything. 4) 4) To install the bumper back, I assume to do the reverse what you did in the video? - Yes, just reverse the process and you will end up installing the complete bumper. Glad you figured it out If this video helps you in any way, please consider liking this video and subscribing to our channel :)

[@tonysanchez4211]

Very helpful video. Question. can i swap a 2017 le front bumper to se? Sry

[@HowItsFixed]

As long as the front grill is same and there is no fog light then it should be fine

[@patrickprendergast9589]

verry helpful going to do it for my girlfrends car

[@SirD31V1D]

Hello! For those clip retainers that are in both sides of the fender, the clip retainers that are in the middle. What is the part number of that screw? I got the clip retainer but it does not have the screw/fastener. Thanks! Nice video as always!

[@HowItsFixed]

Hi Jose, Plz share the minute of the video you are referring to.

[@SirD31V1D]

@@HowItsFixed It would be 2:10 and 2:32. The fastener that goes in the clip, what is the part number or type of fastener?

[@HowItsFixed]

@@SirD31V1D They are actually two different part numbers 1) 5387958010 2) 4774958010 Could be found in Ebay or Amazon.

[@SirD31V1D]

@@HowItsFixed Thank you! The second part number is the one that I was looking for. Ty!

[@HowItsFixed]

@@SirD31V1D Happy to Help 🙂