DIY: Building 2-Way 3-inch Pods Using 3D Printer.

"From Digital to Tangible: 3D Printing 2 Way Pods with STL Files Made Easy to Print!"
Curious about 3D printing but unsure where to start? Look no further! follow the 3D car Audio Page. / audiocarworld

[@nmarq005]

New subscriber and this is dope!

[@ZoeyR86]

I'm actually building dash pods for my 5.25 2way sets for my 2006 scion xb. 3d printed in ASA on a bambu lab P1S. I have a full 3d scan of the dash with and with out the stock speaker covers and A-piller trim. using it with an offset and some modeling for a perfect flush fit. the pods are ported chambers the DS18 PRO-FR5NEO 5.25" and DS18 PRO-DR1.354 1" Throat Twist On Compression Driver at the base of the pod uses the print and windshield as the horn. once this is all working i have a pair of 8 and 10in neos for custom door builds followed but a single 15in sub in a custom rear box tuned to 29hz

[@ACW3DDesigns]

ohhh!! That will look great!! Would be great if you could share this with the Group when done.!!! will be running challenges soon with the 3D Car Audio Group. facebook.com/groups/3dcaraudio

[@benjaminthe1st]

been looking at this as an option. For automotive thinking ASA over PETG, although still need a controlled environment to address stringing and offgassing... My application is a 96 Rover Mini Cooper, and trying to figure some customer pods for the door card, and a custom box for under the back seat possibly some 6.5 ported. I love this type of innovation.

[@mohammedali-nj1ig]

❤

[@thatoneguy530]

How do I get the file

[@ACW3DDesigns]

PM me on FB facebook.com/AudioCarWorld

[@kendrickcasanova9938]

*PromoSM* 💪