DIY Circuit Etching for Guitar Pedals.

[@bluesagent]

I hear your pain and frustration brother🙏 I know it firsthand😅 1. Start with much smaller board projects 2. Use Mini Electric Handheld Drill with 0.7mm bits 3. Experiment with "Photosensitive Dry Film" method (instead of "Toner Transfer") and the most important thing is: Don't lose hope!!!💪🤘

[@unholyaudiochannel]

Thanks. Yeah just felt like sharing this in documenting my journey of pedal building. Thanks for watching!

[@TheIsahn]

I totally understand you , I did a pedal circuit yesterday but it was a small circuit it took me two days to finish. It demands lot of attention to the process

[@unholyaudiochannel]

Yeah not sure i have the patience to go through this agian lol

[@loudbigvonbeefoven]

Was there a reason for soldering on top of all the copper runs? I've not ventured to the circuit board side of things before.

[@unholyaudiochannel]

Because over time these wear away or can do oxidised with the air I think

[@felipemartins2310]

Hello! What is the name of the chemical you used to corrode the plate?

[@unholyaudiochannel]

Ammonium persulfate

[@felipemartins2310]

@@unholyaudiochannel Thanks!