DIY H D Compensator Bolt Tool

A tool to assist in removing the compensator bolt or clutch nut. No more using a block of wood!
DISCLAIMER: MARK YOUNG MAKES NO WARRANTY/GUARANTEE, EXPRESSED OR IMPLIED, AS TO THE RESULTS OBTAINED FROM THE USE OF THE INFORMATION CONTAINED IN THIS VIDEO OR ON THIS PAGE/PLATFORM, DIRECTLY OR THROUGH THIRD PARTY SHARING. UNDER NO CIRCUMSTANCES WILL MARK YOUNG BE RESPONSIBLE OR LIABLE IN ANY WAY FOR ANY CONTENT, INCLUDING BUT NOT LIMITED TO, ANY ERRORS OR OMISSIONS IN THE CONTENT, EXPRESSLY OR IMPLIED, OR FOR ANY LOSS OR DAMAGE OF ANY KIND INCURRED AS A RESULT OF ANY CONTENT COMMUNICATED OR IMPLIED IN THIS VIDEO AND/OR ON THIS PAGE/PLATFORM, WHETHER BY MARK YOUNG OR ANY THIRD PARTY. IN NO EVENT SHALL MARK YOUNG BE HELD LIABLE FOR ANY CERTAIN, SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OR USE OF ANY INFORMATION COMMUNICATED ASSOCIATED WITH THIS VIDEO AND/OR PAGE/PLATFORM. THE INFORMATION PROVIDED SHOULD NOT REPLACE PROFESSIONAL ADVICE. THIS AGREEMENT ALSO EXTENDS TO ANYONE AND/OR ANYTHING, THIRD PARTY, WHICH MAY BE ASSOCIATED WITH THIS VIDEO, PAGE/PLATFORM, AND/OR MARK YOUNG. MARK YOUNG MAY, AT ANY TIME, REVISE THE INFORMATION ON THIS VIDEO AND/OR PAGE/PLATFORM WITHOUT NOTICE, AND MAKES NO COMMITMENT TO UPDATE THIS INFORMATION. NECESSARY SAFETY EQUIPMENT/ENVIRONMENT, DISPLAYED OR NOT, DISCUSSED OR NOT, IS UP TO THE USER TO DETERMINE WHAT IS NEEDED FOR THEIR OWN SAFETY, THE SAFETY OF OTHERS, AND PROPERTY.

[@cheezit58]

Mark thx for this video, I tried everything from a rubber pad to lots of heat with a torch and nothing worked. I loaded up my Harley in the back of my truck and was going to head out tomorrow morning to a shop to get them to impact it off and I tuned into youtube and ran into your video and WALLA!!!! I was able to remove it easily. It was tight but it did come off. I just wish I would have saw your video before I loaded up the bike and strapped it down which took me a good 30 min. Oh Well.I know you probably got the idea from another video but I thank you for reposting the idea. Thumbs up from me my freind👍.

[@wobblysauce]

Good ol flat screwdriver

[@randymccalla9995]

Was easy to make one wasn't It, I got tired of chipping the wood stuff, Found some quarter inch thick bar stock at Home Depot and then after fitting one, I filed the corners round on the ends..oh and I left off that I made one 6.6 in. Long and that length seems to work great too.