Thank you so much for the detailed explanation. I really appreciate you showing us the two different shower drains and the measurements for each one.
@simonproatl Жыл бұрын
Glad it was helpful!
@waynehaney87423 ай бұрын
I wish that you were in the Memphis area. I wish I could find someone here to install a shower like you do it. Great videos. Thank you for posting them.
@simonproatlАй бұрын
It's hard to find a quality people to do a quality work and it's even harder to do quality work and make a living. Thanks for watching :)
@Patephal5 күн бұрын
Hi I got a brand new basement and they poured cement over the shower drain and mark an X where the drain is, so where do I crack the cement? Around the X or right the X to find the pipe ?Thank you.
@simonproatl5 күн бұрын
Hard to tell usually they will leave a pipe that sticks out.
@marypaino1327 Жыл бұрын
Great tips, short and sweet
@simonproatl Жыл бұрын
Glad it was helpful!
@HookedonHD14 күн бұрын
I need to do this on my first floor with concrete floor. Do you have a series of videos I can watch from start to finish for building a shower from the ground up? Thanks in advance!
@simonproatl13 күн бұрын
I have few videos that will show you how to build a pre sloped pan, install liner and build shower pan.
@vinhgolf Жыл бұрын
i have a question cutting the 2" drain PVC pipe, when using the white or gray oatley , why only cut 1/34" for white and 2" if using gray ? is it a rule to leave 3/4" ?
@simonproatl Жыл бұрын
The bottom of each drain has a different length. If you cut your pipe flush with the concrete and lets say you are using gray drain then you will have too cut off 2" from your pipe to fit your gray drain. You should have 1/2" to 3/4" of your PVC pipe inside your drain.
@vinhgolf Жыл бұрын
got it...thank you@@simonproatl
@GreatTimesNY2NC10 ай бұрын
Where did you get the white drain from ????
@simonproatl10 ай бұрын
Home Depot
@MikaylaCrane-bh8yd5 ай бұрын
Ok I think I did this wrong 😭. My basement shower was stubbed in. I poured the mortar already and thought I was supposed to cut the drain pipe and fit the drain fitting after the mortar dried. What do I do now?!