DIY - Install Shower Screen

[@GrouseGarage]

Was that attached to a solid brick wall or brick veneer? Are the wall plugs tapped into anything solid behind the wall (like brick or timber), or do they just locate into the wall tile and villaboard only? Good vid. Cheers.

[@ronniemckenzie2037]

How was it that he didn't compromise the wet seal? Those plug were 60mm so they would have gone straight through it?

[@nicolasd2553]

I'm not getting how you can fit the fixed panel at 870mm when the door side is 880 (before u add extra for gaps and hinge) !?

[@stevemallibull]

What are the measurements if the shower is 1000 X 1200mm ?

[@liulorna381]

cool thanks

[@OnlyOneFengDynasty]

very nice

[@butterfly601000]

Does what it's supposed to do. Poor slowly my friend.

[@MAYER213]

would help if you mentioned 8mm or 10mm glass. Presume from measurements that it is 8mm

[@rogerfranklin5823]

10mm says on the website. Hope that helps....

[@trip-tracks806]

Wow, those floor plugs compromised the waterproofing. Don't do this!

[@berniesquires1721]

if it's a 900 wide shower why is the centre of the glass 870?

[@marcelchalhoub3801]

maybe the brackets are wide

[@user-jl8cu7bc4t]

Я не понимаю, а силиконовый герметик через 5-10 лет как менять?

[@j21280]

You could slice it with a Stanley knife to remove old seal then clean and dry area thoroughly and re-seal.