DIY Install: Spec-D Projector Headlights Ford F250/F350/F450 [Halo LED] (99-04) in Black or Chrome

[@Redline360]

Check out the incredible price on these here: shop.redline360.com/products/spec-d-projector-headlights-ford-f250-dual-halo-led-99-04-black-or-chrome

[@chadwatkins5861]

Can't adjust the lows on these lights. Picture on how to adjust on redlines website show the high/low beam adjustments are just on the high beams ...how does that adjust the low beams? I have these lights and the lows are pointed in the sky! Came that way out of the box ...need some clarification on how to adjust them besides moving the whole headlight housing up and down which doesn't look good against bodyline/ fenders

[@DemetriusSims-f5u]

I have these as well. The low beams are not adjustable and they really suck at night because the light shine up in the trees instead of on the ground.

[@hauhnts]

how do you get the halos on? i have them but i can’t get them on. they turn on whenever i use my turn signal tho

[@ChelseaCaban]

Hi so are the two halos, three small led on the sides and amber lights all set to be a running lights when the truck turns on? So when I turn my lights on at night the only thing that changes is the center of the halo lights up? Is that correct?

[@pappachuco]

How do you adjust the low beams? Also, is it normal for the high and low beam housing to have a 1 inch gap from the main housing? I can literally see the internal wires through the gaps.

[@TheGamingChad.]

How big is the lift? Also 37s?

[@burrejo]

These don't require any cutting to fit?

[@larryadam3627]

Contrary to this video, the 2000 Ford F-250SD will not light both bulbs (high & low) when you switch to high beam. The factory lights operate on a seperate circuit for low and high beam. Thus, attempting to get all four to light will result in all being lit no matter what you set the headlight switch to. Also, to make the led & halos work irrespective of with beam, you need to wire those to the parking light circuit and this works but will require separating those connections should you ever want to remove the lights. In ending, these are petty cool lights and after a drive on back roads they work pretty good and the high beams a real goo.

[@trainfanboy2000]

What is that music at 2:36?

[@Redline360]

Sorry, not too sure.. it was from KZbin's library.

[@runswithsisors]

junk not bright at all and you cnat adjust them

[@Redline360]

They are probably night bright because they need adjustment. And you can adjust them, we have an image on the product page that shows how to do so.

[@larryadam3627]

You sure can adjust them. To some extent with the upper mounting posts and there is an adjustment on the backside for the low beam but you would have to take the light out, adjust, put it back in, and see what effect you got (pain in the butt and for me, No Way) I got mine as close as they need to be.

[@chadwatkins5861]

Could you show or make a video on how to adjust the low beams? I looked at your product page and I see the adjustments for the high beams but not the lows... picture on your site shows on how to adjust the beams but says high/low beam adjustments and the adjustment screws are only on the high beams?