DIY Jeep Offroad Custom Length Driveline Build - Cheap and Strong!

In today's episode I build myself a new custom rear driveline/driveshaft for my Jeep Grand Cherokee using simple tools and supplies. THIS IS NOT A HOW-TO VIDEO. Do not attempt this same technique on your daily driver vehicle. this is not balanced and is only used for a trail beater vehicle.
Music -
Motorsport - by Retnik Beats
TOKYO SWERVIN - by Retnik Beats

[@davidwhelan4833]

Came for driveshaft build, subscribed for race quad in the background... braaap

[@BackyardBeaters]

Haha hell ya! Moto used to be my life. Now days I just ride at the dunes

[@BayWop]

Your u joint clip is just hanging on for dear life also lol

[@superboogen]

Ahh buddy next time try heating the OD pipe up to get it to move...:D not bad not bad ! Good job.

[@rebeccastamper6673]

How thick was the wall on the 2" pipe

[@joshestess]

What is thickness of the wall on the 2" pipe

[@nxtleveloffroad5386]

How off balance was it? If at all

[@BackyardBeaters]

Hardly noticeable up to like 65mph. Then You start to feel it a bit. If you plan on going faster than that you can take it to a driveline shop and they can add weights to balance it for you afterwards.

[@kawyamsuz]

Out of phase, no seal, no grease, and too short?? You need a new mechanic!