Всё наглядно, всё понятно даже без перевода! Спасибо!
@wellbelacy10 ай бұрын
Your video was a lifesaver. Thanks for posting.
@tannerjthomas10 ай бұрын
Glad it helped
@barrybruckner43342 жыл бұрын
THANK YOU SO MUCH
@marianbacher983 жыл бұрын
Am I wrong, or did you forgot the cylinder base gasket?
@tannerjthomas3 жыл бұрын
I put it on I accidentally edited it out in the video though.
@dustinchandler811110 ай бұрын
You forgot the spark plug o-ring under the cam cap
@tannerjthomas10 ай бұрын
Must have gotten edited out.
@hadenmiller7397 Жыл бұрын
I know this is old, but what year is this one? Im doing a 2014 kx450f and want to know how similar it will be.
@tannerjthomas Жыл бұрын
It’s a 2017. They are very similar.
@hadenmiller7397 Жыл бұрын
@@tannerjthomas Thanks for replying so fast! this video is going to be one of my main helpers alongside the manual. Hopefully I can get it done without any trouble.
@joeplaugher64053 жыл бұрын
did you half to replate the cylinder thanks
@tannerjthomas3 жыл бұрын
No my cylinder was good and within tolerances still.
@jaybloxx_22 жыл бұрын
When I put in my intake side witch being my last side cam shaft the chain is too tight and I have it at top dead center also still hve my tensioner out only replaced my gaskets and piston any idea?
@tannerjthomas2 жыл бұрын
Is the stator cover off? It may not be engaged full on the teeth down below on the flywheel gear
@jaybloxx_22 жыл бұрын
Could be that I don’t have my stator cover off since I didn’t go that low in the build but if I just take the cover off I’ll be able to see the teeth?
@tannerjthomas2 жыл бұрын
@@jaybloxx_2 yep if you just drain the oil and take that cover off you can see the whole timing chain top to bottom.