DIY Match Saver

do it yourself match saver.

[@bnsf9161]

sorry about taking so long to respond. I used grey pvc. basically go to menards and test a 12 ga shell in it until you find one that is tight. just cut it to lenght and use a belt sander to sand the shape. if it is too loose you can heat it up and pinch it a little.

[@bnsf9161]

I had it dipped.

[@ftahdriwich9859]

😳😳👍

[@iandonahue1040]

That's a badass stock set there man, where'd you get that?

[@mozambiquedrillteam1148]

What did you use to make this?

[@bnsf9161]

grey PVC pipe.

[@tac-z3363]

PVC pipe? Some kind of thermo plastic like kydex? What did you make it out of?

[@LillianGardner0214]

Looks like gray PVC conduit pipe to me. Good idea.

[@grinchyface]

can always count on an American shotgun to sound like a plastic toy

[@bnsf9161]

It’s not exactly high dollar and it took forever to get it to run reliably…. Once I did it was awesome. Until then it was horrible.

[@tombosleyv2]

doign this tonight. seems like an old video so maybe you have changed technique, but you do not have to hit bolt release if you press shell down onto lifter. very cool tho thanks

[@bnsf9161]

better late than never I guess. sorry about that. I don't know the answer to your specific question but I can say that hitting the bolt release would be faster.

[@steveharutunian5440]

Cool device but can’t believe you’d be so unsafe as to demo that inside. Not smart.

[@bnsf9161]

You just called me stupid… it was a dummy round… the irony of your comment is a thing of beauty. Who is the dummy now? ;) xoxo