DIY Rod Dryer using a BBQ rotisserie kit.

Рет қаралды 6,890

Күн бұрын

Пікірлер: 16

@benskai2475akurfishing 8 ай бұрын

Greetings coming from Indonesia, healthy greetings and greetings from fellow fishing rod craftsmen and senior creative greetings Thank you senior, your knowledge is very valuable for us

@paulnoble684 8 ай бұрын

Thank you!

@benskai2475akurfishing 8 ай бұрын

@@paulnoble684 Thank you again senior

@ericpierce4510 Жыл бұрын

loved the video. A question I have is at 2:43 in the video you show your rod in the wrapping jig. Where did you get the roller wheels and what brand. I like this set-up. Thank you for your effort of educating the masses that you don't have to have the high cost store bought to get a job done. Fancy equipment don't make it a better end product.

@paulnoble684 Жыл бұрын

@ericpierce4510: Thanks! I put that rod jig together almost 25 years ago! The wheels were found at a hardware store - I think they were for sliding closet doors. Then found some O-rings that fit the grooves.

@ericpierce4510 Жыл бұрын

@@paulnoble684 Thank you sir.

@bykergus Жыл бұрын

Paul - on that rod wrapper you have on the video - you measure it at the 3:14 mark. Where do you get those wheels with the rubber o-ring on them? I am looking for a source for those wheels/rings .. Thanks in advance. Gus

@paulnoble684 Жыл бұрын

@bykergus: They are actually wheels for sliding closet doors that I found at Home Depot. You have to buy the orings that fit them separately.

@naturalmystics-kd9vt Жыл бұрын

What bbq machine did you get the machine out of smart move

@paulnoble684 Жыл бұрын

@natural mystics-kd9vt: You may want to watch the video again. Starting at the 0:27 mark, I clearly state the source of the specific rotisserie kit used. I also stated that any brand of rotisserie kit could be adapted for this project. Hope that helps.

@stevewright5642 9 ай бұрын

Why not mount the motor lower use several v roller stands and an elastic band or thin large O ring stretch over a pulley mounted on the motor and over the end of the rod handle to drive it

@paulnoble684 9 ай бұрын

Stevewright5642: There are a myriad of ways to modify this basic design. The direct drive, the simplicity and the cost effectiveness of it are aimed at the beginner who might only build a rod or two. If you want to customize it to suit your personal needs, fill your boots!