DIY Slitting Saw Arbor

[@homemadetools]

Good work yet again. We shared this video on our homemade tools forum this week 😎

[@David-hm9ic]

Looks good. I just made one that looks very much like yours. It's a lot more work than it appears in a short video. Tolerances and finish requirements make it a precision job.

[@garrettguitar]

Very cool build. Nicely done!

[@alissoncapelin6528]

Sanches Blanes... One of the best bench lathes in the world. Proudly made in Brazil

[@SergeiPetrov]

Is there an adjustable runout design option?

[@StevenStyczinski-sy8cj]

You’re supposed to put the shoulder on the arbor not the cap. Then you only need one precision fit. And undercut the fillet so the saw is held by the outside of the arbor and cap.

[@stanisawzbik5336]

Jak chcesz żeby miedź była miękka to po rozgrzaniu włóż ją w wodę. Z miedzią postępuje się odwrotnie jak że stalą.

[@rickpalechuk4411]

Nice! Just subbed Cheers

[@FaskaRestoration]

A little bit of runout in the saw is on purpose.

[@mk6595]

Just so you know...Nobody ever gets a slitting saw to run true. Ever.