DIY Splasher Prop Thumper for Stripers (Striped Bass), Hybrids and White Bass

[@FreshwaterSouL]

Yes it will throw water on ya,I made mine like this last year and had to do do some adjustments on it

[@doingusa]

If you run it very fast the guy on the back deck his feet will get wet. I need to make a splash guard

[@doingusa]

I need to come up with some sort of a shield

[@martyadams3915]

Mapp gas didnt work because between the vise and the two clamps you had so much heat sink mass it would take a long time even to get to 700 degrees

[@doingusa]

Marty. Thank you. I felt like the 1/2 inch piece was stopping me I didn’t even think about the vice being part of the equation.

[@FogmanFisheries]

You really don't need to go through all that. Just drill the prop and 1 inch pvc cap. Bolt to 1 end of the stock prop, and you have a good splasher. Trust me. It works.

[@mikebruns1966]

Why not just epoxy those end caps right on the original prop

[@doingusa]

Well I thought about it. but sometimes I use this little 30lb trolling motor to push around my 12 foot boat. so I just loosen one nut and now I can change props and still go bass fishing. Thanks for the reply mikebruns1966 and thank you for watching.

[@blindabinda1234]

What the heck is this thing for?

[@LuckyJrBoys]

This vid is almost at 1000 views and its at 955 views!😀😃

[@Wewhoooooo]

Why not just find the guy that makes them and order… they are cheap!

[@doingusa]

Good idea. I did look for his number online and spoke to several guys at the lake and got tired of trying to track him down. Mainly I just wanted to see if I could do one. Thank you for the comment

[@86753091956]

Google Michael's Taxidermy in Brenham, TX , He sells them

[@Wewhoooooo]

@@doingusa that’s valid!!!!!!!!!!!!!!!!!!!!!!! I found the guy didn’t want to put his info because i don’t want people to just jump to it and now everyone is doing it….. I learned . Found info lol

[@charlesfoster8814]

I made my prop in about 20 minutes with one inch aluminum bar stock and two CPVC 90's. Heated the bar stock so it would melt its way into the CPVC. Been using it for a year and half without issue. A splasher is the number one must have to catch Hybrids!