DIY Vent Hood for Laser Pecker 4

How to build a DIY vent hood for your Laser Pecker 4
Here are the parts you will need.
VIVOSUN D4 4 Inch 195 CFM Inline Duct Ventilation amzn.to/3LjcmRp
If you want other fans or variable speed check out these amzn.to/44S8k9i
Hoses:
2 1/2 inch PVC Hose But the length you thing you need amzn.to/3Rmw1no
4" PVC hose to hook to the fan or you can build the entire thing with 4" if you do you will not need the reducers amzn.to/48gHquG
4-Inch Hose to 2-1/2 Inch Hose Reducer amzn.to/3sSvVJR
Hose clamps all sizes with thumb screws amzn.to/3sQoYJk
My boxes from Costco are 11.8 in. x 15.1 in. x 9.4 in. they were $25 for 4 in the store they had them online but they were $69 for 8 better deal in the store.
Amazon has many Shoe Boxes but be sure you find one wide enough the laser pecker is 8 1/2 wide amzn.to/466Po80
This one says its 8.5 wide amzn.to/3RlkowR
Laser Pecker 4 is now on Amazon
amzn.to/45VjY4Q
The Laser I use for engraving knives
Laser Pecker 4
www.laserpecke....

[@cynthiasymons]

Clever using the UV resin! Your video (like the others about the LP4) are timely for me. Mine is finally arriving on Tuesday! In trying to figure this out for myself, my challenge was that I don’t have any good place to run a vent to the outside. So I opted for a small air purifier system with a 3 stage filter that I hope is going to work well enough so I don’t get poisoned. LOL I loved your shoebox solution-you are wonderfully creative. :)

[@ALXSHARPEN]

I did order the laser pecker filter but mostly for doing it in places other than my shop. That said the #1 solution is always to vent outside so even if you had to build something to put in a window using a fan like I made and a piece of wood with a hole that you could just bring the window down on while using is far better solution than trying to filter the air clean.

[@ALXSHARPEN]

So far the only horrible things for me were plastic. Metal not bad ,wood lots of smoke but smells ok but since doing this vent fan I get nothing it literally sucks every thing out so if there’s any way you can figure something like this out I would do it getting poisoned 🤢 would definitely not be fun

[@marilynwilson3599]

I purchased the Laser Pecker 2 and have been looking for a solution and yours seem to be the best I've found. I was beginning to hate that I purchased it until seeing your video, I think I can build this by myself. I've been unable to use the laser pecker because it is very cold where I live and lasering inside without filtering isn't an option for me. Everything I read suggest it is very dangerous (health wise) to not filter/exhaust this unit. Only thing is, I have to figure out what size tubing I need since I have the 2 and not the 4 which you are demonstrating here. Thank you for sharing. I forgot to ask, did you ever receive your vent hood from Laser Pecker. If so, how is it working for you in comparison to this?

[@ALXSHARPEN]

I have a new one and an updated video and a better tent now made a new more permanent solution the tent I used is in my laser section of my tools if you go to the “for sharpeners” section of my website you will see the tent I now use. The laser stuff is at the very bottom alxsharpen.com