Dodge Journey Power Steering Rack Replacement

[@elbomber123]

Omg this two videos you posted about hidráulic pump and Rack are priceless

[@davidkaczmarek8551]

I thought my it was just my tie rods. Looks like my rack is toast too. Thanks for the walk through. More than a few tips here that'll save me quite a bit of frustration. Thanks.

[@palsplace]

Glad it is useful. Good luck with yours!

[@BrentPiniuta]

Very helpful - thanks for posting this!

[@palsplace]

You're welcome! Thanks for watching!

[@JaySosaNY]

Helpful video my man I’m a ford tech but drive a journey my subframe broke in half and I used you as a guide I wasn’t changing the rack the so I separated it from the subframe and hooked it back to the knuckle when I dropped what was left of the subframe

[@palsplace]

Wow! Bummer! Glad it helped you get going again.

[@michaeljones5768]

Thank you for taking the time to make this video. I while have to replace mine unfortunately I do not have a hoist

[@tmos1394]

Blocks my dude. Anything's possible with the will to get it done.

[@dodgeking9194]

Thank you for making this video to help navigate through this nightmare job. Its sad to say but American cars today are in the back seat when it comes to quality in manufacturing. Its no wonder why Asian cars are so well known for their reliability and serviceability and have overtaken everyone else.

[@palsplace]

I agree. Glad it was useful!

[@johnnyblaze6000]

Love the video def. A big thank you for this. Tutorial video. But I want to ask why did you replace the rack what was wrong with it that you replaced it?

[@palsplace]

No power assist, even after replacing the pump. Still worked, just really hard to turn.

[@johnnyblaze6000]

@@palsplace oh, ok, understandable thank you for taking the time to reply back 🙏

[@88Darkhorse1]

Love the video it was perfect but i must ask.. if your going to go through all that work, why put in a used rack instead of a new one?

[@justinnourse8873]

Wat size are the rack bolt size I need some but can't find them

[@johncummings973]

what was the situation why you changed the rack to begin with

[@palsplace]

It had no power assist. It was very hard to steer. No whining or anything. Just hard to steer.

[@palsplace]

I hope they were helpful!

[@DJM6.6]

How did you get that dust boot out? I can’t drop the subframe down far enough to get it out.

[@palsplace]

Did you unsnap the white clips on the inside by the floorboards? After you unsnap those, you should just be able to push it down through from the top and then the boot comes out with the rack.

[@magfix]

Thanks a lot, master!

[@palsplace]

Glad to help!

[@NoMurrcyDidit]

Thanks for this.

[@Tedybear315]

It's a pain. Our rack is fine, but the engine cradle (frame section) was fully rotted out. We're in the middle of the assemble. I left the rack in place and dropped the frame section. (As a precaution, We had the rack supported on jack stands to keep it from pulling down on the assembly to hard while we took several days away from the project.) As I'm watching the "marks" on the frame assembly. Didn't do that on ours. Then again our frame was junked and being replaced :-)

[@palsplace]

I agree! It is a pain!