Dowel Pin Puller

[@keltecfan]

Thanks for taking the time to make these videos and thanks for sharing this info Tom. I have the small Kent Moore slide hammer type of puller for the 6L80/90 roll pins. It works ok. I use the Snap On pump puller in conjunction with it instead. They can be a bit of a pain if the pins are buggered up. Have yourself a wonderful Labor Day.

[@CurmudgeonTransmission]

You as well.

[@jeremyking5684]

Thanks tom,i been looking for a dowel pin remover.

[@CurmudgeonTransmission]

No problem 👍

[@omegapolat]

thats what i excatly need. last week broke one of A selenoid pin of 4L30e, trans was on car. so i let it go (B was a little tired, i could change it, normaly i change both of them everytime) just seems not fit for 4l30e, selenoid socket very close to pin.

[@CurmudgeonTransmission]

Thanks for watching.

[@jeremyking5684]

Hey tom i rebuilding transmission in my sons 99 jeep 4.0 4×4 ,we got it out today its a 30-43le is that the same as a aw4? Whats the best kit to get?

[@CurmudgeonTransmission]

Yes, it is. Transtec with Raybestos clutches.