Dr. Flexo - Best Practices for Plate Mounting

[@bubbadennard]

You wish, Todd! This is tesa all the way my friend.

[@mr.t6046]

It appears that you have used Lohmann DuploFlex 5.3 seeing how easy of application and demount!!!

[@jonyao76]

lets say you have a cylinder of 620mm and a plate of 540mm. how would you know where to place it? should it be 40mm on each side?

[@ClayALL]

Nice :)

[@chrisframbers8267]

I wish that Tesa made letterpress tape for an old 4300

[@markandy]

Hi Chris, thanks for your comment. To view all of Mark Andy Print Products consumable offerings please visit: shop.markandy.com

[@eddiediedericks535]

I prefer 3m tape more than tesa

[@markandy]

Hi Eddi, thank you for your comment. It's always depends on the label design, substrate etc.

[@amanyadbalh5655]

مساء الاحلام والامال الجميله المفيد ه النافعه غير مضرة لاتسان

[@PHOENIX967]

You are wasting too much tape 🤷‍♂️

[@markandy]

Thank you for your comments

[@jbsmarklinmodellbahn1728]

Warum werden keine Schutzhandschuhe beim Umgang mit Lösemitteln getragen? Schwache Vorstellung.

[@captainmorgan8907]

Quite possibly the worst demonstration iv ever seen😊

[@josemeza7128]

This is too slow and not accurate, a real pressman doesn't use that big useless plate mounter, the old table top model is easier and better.