Drive belt and variator replacement on a 150cc GY6 Chinese scooter

[@carly-beatz-DJ]

Without doubt the best GY6 maintenance vids I've seen. Thank you so much!

[@SLAYER-nm5zw]

Very underrated channel. Well done sir

[@frednetherlands887]

Thank you. The variator locking tool can be found for less for those who have less to spend.

[@exploringwithadam297]

made my own so it was free :)

[@successmindset-samir1272]

Very informative. Thanks a lot

[@dendys04]

4:26 yeah i was removing kickstart mechanism and forgoted to this little bushing and it flyed out thanks god nothing happend

[@cameronsanchez7262]

I changed it and now i hear a lil slapping or clacking noise every now and then? Any tips?

[@Yamazaki112]

I have a Ryobi 160 lb torque impact wrench but it will not take off that bell clutch bolt no matter what I do. I also have a 250lb ft. torque breaker bar that also can't seem to remove the bolt. Idk why I can't just use a screwdriver to hold the Bell clutch in place and break the bolt using the torque wrench or impact wrench.

[@chrislavalley4062]

I have a question if you need to replace the clutch output shaft how do you put a bearing on the new one

[@charizard365]

Would this fit most Chinese 150 cc I have a taho 2022spark?

[@alexandernaigbaver3302]

What screwdriver you using or recommend?

[@ironhead320]

What would you recommend for a quicker take off lighter weights or heavier

[@LabCoatPaul]

lighter weight rollers will keep the engine at higher rpm and give you better acceleration

[@C.nlaodesigns]

Why does my belt keep breaking on my 150 cc Chinese scooter. ??

[@dendys04]

the rear half pulley is broken buy a new one and replace it

[@bocephussammons6298]

How many miles was this

[@LabCoatPaul]

8,000 miles