DT Swiss 3 Pawl Hub Bearing Removal - No Special Tool Needed

DT Swiss 3 Pawl Hub Right Hand Bearing Removal
If you find the videos helpful and would like to make a small donation to help support the channel you can do so here www.paypal.com...
Buy me a coffee
www.buymeacoff...
Support the channel via the Patreon Page
/ freetocycle
Follow me on Instagram
www.instagram....
[e-mail]
Thanks for watching.

[@liamgaul]

How did you remove the inner axle first?

[@빨간등대-s8t]

I enjoyed the KZbin material. Subscribe. Please give me the purchase link for the setting tool

[@Jose-kx8nh]

Are this bearing 6902?. We can make the same with 6000 bearing?

[@JohnnyRabbitQC]

Hello! Thanks for the video. I don't know if it's normal wear but I rode about 6500km in all weather conditions with my DT Swiss 370 and the bearings are gone. I suspect the seals are not full contact seals. What is your input on that? Thanks.

[@9987molly]

Nice video. I have a 6903 bearing on my rear hub and drive-side doesn't' want to pop out for some reason. I'm guessing it's because the ratchet lock ring is in the way? Should I need to remove it?

[@FreeToCycle]

Depends what hub it is!

[@glennoc8585]

I've swapped over freehubs with the same amount of pawls but different brands and i also put a 3 hub or 4 pawl hub into a hub with less or more pawls. it was some years ago but it got me out of a .spot/

[@tefer1982]

What press tool are you using?

[@benroy-b6l]

💥💥💥♥️♥️♥️