DTPerformance -ENDURAPIN Door Hinge Pin Install on a FIRST GEN S10 - Recommend over part store pins!

In this video I compare the ENDURAPIN (LIFETIME WARRANTY!) door hinge pins to the part store door pins and show you how to install them. The ENDURAPIN is hardened abrasive resistant tool steel as compared to the mild steel part store pins. Links to the FIRST GEN S10 TRUCK door hinge pins below with the GM door spring removal tool. Thanks for watching. You know what to do - LIKE - COMMENT - SUBSCRIBE!
Links
ENDURAPIN FIRST GEN S10 TRUCK - BOTH DOORS
endurapin.com/products/1st-ge...
GM Door Spring Removal Tool
www.amazon.com/gp/product/B01...

[@chadbaker3410]

Awesome video! Thank you! I was dreading this job, but now I'm ready to go tackle it.

[@alexadams9644]

Thank you. I have 5 s10s to do.

[@OldDime]

For those like me who will opt for "stock" pin kit due to cost, I'd like to share a hint. Prior to installing your bushings, be sure to pre-lubricate them. Take each of them individually and put it on your thumb in the correct place where you can press against it with your index finger with the most force and obtain a seal on both ends. Place a bushing on your thumb and fill it with engine oil. Then, use pressure between your thumb and index finger to squeeze the ends of the bushing which will force the oil to weep through the bushing material. Maintain pressure on the bushing until oil is oozing from all around the outside. Bushing(s) ready to install.

[@stevea6722]

I recommend changing the pins with the hold-open roller as well while you have the door off, a lot easier that way. Also, maybe use hitch pin clips instead of the roll pins in the hinge pins.

[@maxpain9111]

I’ve got a 91 that I need to swap out the pins nice job easy peezy 👍

[@datnotme9921]

Thanks for the tip 👍 endurapins

[@RubberSideDown2]

Just got some dorman pins online. Good tip on holding the door up but I'll have to use a low branch and some rope. The holes are kinda oblonged but no welder so I'm going to hope for the best they hold up for awhile or ill have to get steel bushings.

[@allencobbs4047]

Got those for my s10 but got over sized bushings my where wore really bad good product