Ducati Monster 696 Walkaround & Gear Indicator

[@trapparty2792]

hello, could you tell me: I have such a problem, when I put the seat in place, a gap is formed between the front of the seat and the plastic tank, because of what this is happening? thanks for earlier. ducati monster 696

[@dr.p.t.2500]

What is the size of the gap? A small gab is normal. But big gap means that there is something between seat and tank. Sometime a cable. Mostly the cable of the Ducati Drive Recorder.

[@trapparty2792]

@@dr.p.t.2500 The gap is about 30MM

[@dr.p.t.2500]

@@trapparty2792 that is too much. So then something is stuck between the tank an the seat.

[@trapparty2792]

@@dr.p.t.2500 You are right, it is necessary to check everything carefully and remove the reasons, and it is not very comfortable to sit, I think some kind of interference prevents the seat from getting into its position

[@dr.p.t.2500]

@@trapparty2792 I think it is a cable. When you put the seat back. Look from the side under the seat and check

[@Мишик_Сысоев]

Hi, bro, please tell me how you can replace the original cap for spark plugs, my cap has broken off, I do not know what to do with it, there is only one option, these are NGK LB05E caps,but they are from 5Q resistors,and spark plugs are also 5Q,I am worried that this may cause harm to electronics 💁🏻♂️

[@dr.p.t.2500]

Pull the cap from the spark plug. If you disconnect the battery, there will be no electrical damage

[@Мишик_Сысоев]

@@dr.p.t.2500 I understand) But I'm talking about which caps can be replaced in place of the old ones that have fallen into disrepair? NGK LB05EP? will they fit? Or you could advise me other options, thanks for earlier!

[@dr.p.t.2500]

67110281A this is the OEM part number

[@Мишик_Сысоев]

@@dr.p.t.2500 Thank you

[@dr.p.t.2500]

Normally the part number should be printed on the cable

[@allanzambrano6268]

Hi. would like to know where did you purchase that indicator?

[@dr.p.t.2500]

You mean the small one for tail? Ebay. Just search for Led bike sequential indicator. You will find lots of them. For this bike you will need extra resistance because right and left side have not a common current chanel. You can choose cheap indicators which also last quite long. A very good quality item here in Germany is Kellermann. But those are quite costly.

[@allanzambrano6268]

@@dr.p.t.2500 ok thank you and thought maybe it was a brand name

[@dr.p.t.2500]

@@allanzambrano6268 The best brand name would be Kellermann

[@trapparty2792]

Hello, My Dear Friend ❗ I would like you to pay attention to my comment ❗ I have a question for you, because you are a professional and can give me an answer ❗ Please tell me, I have a broken spark plug cap, it's hard for me to find a replacement, could you tell me which caps of other brands will fit? ducati monster 696 The candle is installed with a twisted tip, respectively, the cap is needed for this particular shape of the candle. I found a seemingly suitable option on the Internet, but, as usual, it is not in any of the stores, such a trifle and it is difficult to find a decent option. There are options, but the quality of the caps leaves much to be desired, or they do not fit in size. I am grateful for the advice!

[@dr.p.t.2500]

You can take cables by nkg.

[@dr.p.t.2500]

Just search for ignition coil M5. Ducati 696. There are lots of them on e.g. eBay. An I use following spark plugs NGK DCPR8E or Denso IXU24 or Denso XU24EPR-U

[@trapparty2792]

@@dr.p.t.2500 Thank you, my friend, but I'm specifically looking for candle caps that hold a spark for a candle) I wanted to buy Ngk, but there are none in my city, maybe try other labels, but I don't know about them

[@dr.p.t.2500]

Have you already checked on eBay. I have seen some from items from US. Cost about 40 dollars. Another brand would be Beru. Part number 0040100503

[@trapparty2792]

@@dr.p.t.2500 Thank you