Electronics and Programming Beginners Guide www.eapbg.com A look inside the SparkFun Hot Air Rework station with a simple replacement of zip ties.
Пікірлер: 12
@extrememod_ahu3 жыл бұрын
Great video! I just bought a new Best BST-863 but it is faulty. The thermal fuse keeps blowing in the wand. The pump (brushless) doesn't provide any air at all it seems. Any advice?
@eapbg3 жыл бұрын
Figure out what is wrong with the pump. Is it blocked? Does it not spin at all? The heating element needs airflow. No airflow will cause it to overheat and the thermal fuse to trip.
@extrememod_ahu3 жыл бұрын
@@eapbg yeah I'm taking it apart to run some voltage injection on the 5v power cable to see if it spins. Any advice on what amperage to use?
@eapbg3 жыл бұрын
@@extrememod_ahu Don't feed power directly into the motor. Being a brushless motor it has to have a controller. Current wise it is hard to say. See what the label on the motor calls for.
@extrememod_ahu3 жыл бұрын
@@eapbg it has no label or any markings other than "CT2" on the motherboard pin connector. I tested it and it didn't spin. Thanks for all your help
@extrememod_ahu3 жыл бұрын
Okay so I made some progress. When I power on the unit the the fan spins superfast for about a second then goes dead. Same happens when I turn off the unit. Feels like a capacitor failure
@kamyrafiq88625 жыл бұрын
I can't adjust the air flow from max on mine... what could be wrong? Everytime I try turning it down it cuts off?
@emblink276 жыл бұрын
Nice teardown! Much safer to use plastic tools instead of knife) Did you figure out the purpose of that button? :)
@eapbg6 жыл бұрын
iRepair TVChanel Nope, it makes no sense that the button is with the power section.