Early access to the newest Eclipson jet, the INFERNO - Maiden flights

[@crazyaces9586]

Thanks for showing us...I made one in PLA & LWPLA

[@MrDaveNG]

Nice flight and review - I’m starting to feel a need for a 3d printer 🤔😁

[@locarshobbies]

Haha I hear ya! You’ll be on the lookout for a printer in no time 😉

[@maxun1]

what slicer you use I got a bambu slicer how much infill you use.

[@locarshobbies]

Hey, Eclipson designs don't use infill in most of their profiles because they design the entire thing including the internal structures, in fact, this is what makes them very compatible with vase mode it's a lot more work for the designer, but the result is a great model! IN their site they have the parameters you need to use for the model :) Good luck if you decide to print it

[@JoeyscustomRC]

Can this be scaled up for a 70mm?

[@locarshobbies]

Since it doesn't use carbon rods I assume you could try, it's not specifically said by the designer, but you can probably try it and see how you go, You'd probably have to make sure you have a big enoguh printer cause scaling the parts could result in much larger pieces and since it's designed for vase mode splitting them may not work You'll also need to design siemthing for servo holders

[@JoeyscustomRC]

@ I don’t think any of those will be an issue for me. I just have a spare 70mm QX motor edf and I’m looking for a cheap, simple, fun project to use it for. They aren’t the greatest edf’s in the world so I don’t want to use it on a more expensive build. What edf are you using in yours? Looked like an XFly

[@crazyaces9586]

I'm eventually going to try it as i have a 70mm & 64mm ​@JoeyscustomRC

[@JoeyscustomRC]

@@crazyaces9586 let me know if you end up doing a 70mm how it turns out