Echo pb770t backpack blower fuel line install. Pb770t primer bulb. Pb770t carb

[@trendwave5615]

Found this video helpful to see how the throttle cable was hooked up. Took blower apart and didnt take pix along the way so this was a great help! Thanx!

[@paulmonroe7022]

Tried to install fuel line kit using Echo instructions and failed - found this video and followed the tips including the cranking alignment and blower is back together and working great. Thank you for posting and sharing the insights - great assist!

[@maxwellmolik9112]

Thank you for posting - followed along and my blower started up!

[@glennlozuke268]

Great video. I replaced the carburetor and fuel lines & primer bulb. It started right up and ran strong for 20mins, then stopped. I couldn't restart but noticed that that primer bulb wasn't pulling any fuel(not working) Any thoughts?

[@vinnieowens6307]

Thanks for the video very helpful!

[@njc110381]

Nice one, thanks. I've been trying to figure out how to get to the line in the tank. Mine has a hole in it so the blower dies once it gets down to half full. I guess that's tomorrow's job now I know how to fix it!

[@smallengineguys]

good luck!!

[@omarvaldez1938]

Hey good afternoon I did that but went I started it it came gas out the filter do I need a new carburetor

[@WaltB2823]

Thank you for this video. Great help

[@smallengineguys]

Glad it was helpful!

[@glennlozuke268]

Great video. Thanks

[@teshuvahemmet3036]

Thanks for the information

[@smallengineguys]

My pleasure

[@DeeM-wv1wp]

Did not need to remove the pull starter.

[@mgomez5606]

At 3:28. How does that cover go on carburetor?

[@smallengineguys]

it just pushes down on top till it clicks in place. mostly decorative not even a needed item so if the tabs are broken that hold it on dont worry about it.

[@mgomez5606]

@@smallengineguys I was being hesitant and pushed down and it clicked. TY again sir. I fu the hose connections and watched you video again. I hooked the fuel filter line to the primer bulb. But all is good.

[@smallengineguys]

@@mgomez5606 nice

[@kathyhytinen3091]

Good info

[@smallengineguys]

Glad you think so!

[@DrPaxIll]

Thank you!!!

[@smallengineguys]

Your welcome

[@doodsomething07]

Thank You good Sir! 👍🏼

[@smallengineguys]

Very welcome!

[@DoctorRickSanchez]

Something about you seems like you can build hotrods lol.

[@smallengineguys]

I built custom motorcycles for a bit. Made my own frames and wiring harnesses. If i had the time i could build anything.