EFFECTS LAYOUTS - Eagle Tutorial Episode 4: Circuit Board Layout part 1

[@alex-murys]

man !!! ... you made a real incredible tutorial, you are the fucking master!

[@PrincePloppy]

Thanks so much for the tutorial. I'm watching it all first n then gonna try and move my design over from LTSpice. The schematic part looks easy enough. This part is gonna take a few goes before i get it. lol

[@danhoward5686]

Hello, thanks for this tutorial. How do I delete the enclosure after I am done with the board? It is showing up on my tplace silkscreen layer and I can't figure out how to get rid of it. Thank you.

[@effectslayouts]

Make sure the back origins layer is visible, then use the delete tool to delete the enclosure model. It's origin point is directly in the middle where the dashed lines intersect.

[@FASTFASTFASTFAST87]

i can't find "package" on sub menus on eagle 9.6.2, why?

[@chloebugg218]

Somehow I turned values off from showing on my board. Turning them on or off under the layer window does nothing. The only way I have found to make it work is to make new attributes for every part. I cant remember what I did to turn them off. Any ideas?

[@riffovlje]

After I draw ground plane wrong and I try to make it again, ratsnest works only on the parts. I cant get the bottom plane as in video or for the first time. I'm using Eagle free 9.6.2. Please help!

[@wesleyfalk492]

Thanks for the guides! Quick question: I'm finding my pads are aligning with the center of the grid and the other components are aligning with the edge of the grid which is causing my traces to be crocked. What setting do I need to change to fix this? I'm using the same size grid as the video. Thanks again.

[@effectslayouts]

I've not run into that, at least not when using a finer grid. Maybe when it's on like 0.05 in, but not when smaller than that. Try bumping your grid down to 0.0125 (assuming you're on 0.025)

[@quanticmar]

Hello, I really love this tutorial, but I have a question, can I avoid doing +9v plane? Would it cause problems? Like undisired noises, and Instead of the 9v plane can I put ground plane at top like at bottom?

[@effectslayouts]

Lots of pcb designers just do ground planes on the front and back. It won't cause any problems

[@TacianoCanassa82]

Can you share the JLCPCB DRC file?

[@effectslayouts]

Adding to the description

[@ABR4X]

error in the link for library

[@effectslayouts]

Fixed

[@ABR4X]

@@effectslayouts Thanks

[@lesstime1678]

habuuuuuuu**&&^%