Elbow with flange in AutoCAD 3D

[@TREADINGVIDEOS234]

What are the commands used the diagram

[@AC3DCad]

I redraw this tutorial with audio, my actual voice not just music kzbin.info/www/bejne/gWaxmKeAgcyHl80

[@zeezeee6254]

dear dia was 65. how did u draw dia of 42 and also there are fillets aroumd the flange... where are they.?

[@AC3DCad]

the OD of the pipe is 72 , ID is 60. The distance from the center of the pipe to the center of bolt hole is 60. The radius and diameter from the center of the bolt hole are 20. From there you can figure out the whole dimension. The distance 42 is the radius of the entrance hole of the flange tapered towards the ID of the pipe. It is in the hand drawn illustration .The fillet, I kind of forgot :) I hope I answered your questions.

[@zeezeee6254]

+AC 3DCad and what about the fillet around flange.?

[@AC3DCad]

i forgot :) fillet is 3

[@zeezeee6254]

+AC 3DCad haha its ok... i got it now.. i can draw by myself now.. :)

[@kapilpundir6486]

U left R3 in 3D?

[@AC3DCad]

I redid this drawing with actual voice kzbin.info/www/bejne/gWaxmKeAgcyHl80

[@Jun4074]

Thank you so much for your videos, it helps a lot! BTW could I get that 2D drawing by any chance?

[@AC3DCad]

I am glad it helps. Do you mean the Isometric drawing or just the 2d with dimensions?

[@Jun4074]

AC 3DCad 2d drawings with dimension :) (your other videos as well...) thank you!!

[@AC3DCad]

I will post it in my blog which is still under construction though I will give you the link in a bit

[@Jun4074]

AC 3DCad Thanks!!

[@AC3DCad]

sorry for the delay, I am working on it now and post it on my blog

[@zeezeee6254]

i found little mistakes in your drawing dear. i need your help to get those mistakes clear. So i hope u ll reply back soon.

[@AC3DCad]

where are the mistakes? I'll be glad to hear suggestions.