DIRECTIONAL OVER CURRENT RELAY WORKING PRINCIPLE|DIRECTIONAL RELAY SETTING|PROTECTION

[@NiteshKumarElectrical]

Wonderful explanation ! You covered point wise concept very clearly !! Kudos to you. Keep on clearing doubts like this. This is just like helping tech young minds and doing free of cost service. As I agree that sharing knowledge must not be restrained by any means. Finally, Thanks !!💐

[@christopherserojano3953]

Thank you Sir, I have watched other discussion on the same topic, but yours is the most comprehensive and intuitive. Very good lecture!

[@NoHeartAnthony]

Many thanks for your explanation, from a trainee commissioning engineer in UK

[@enriqueh8847]

Thank very much for this part 2👍👍👍

[@prabhakarangovindaraj9238]

Thank you so much sir much waiting for this video only 😂👍👏

[@rameshtripathy5978]

Thank you so much Sir for your Beautiful description and it is very much helpful !

[@harshitmishra2308]

Great great great knowledge shared sir

[@mijoizagas3747]

Well done !!!

[@Cromanea]

Great 👍👏

[@jollysingh3949]

Amazing, thank you!

[@tjjanarthananx]

Is there any difference operating region change. For RCA -45 ° and MTA -45°.. please explain sir..

[@nathans5529]

Reverse power relay and directional current relay both are same or some different?

[@anilshemade6048]

In numerical relay in which context the MTA/RCA is used?..MTA is applicable in EM relays...will you plz explain?

[@md.shahjahanali4285]

I cant understand why the angle is theta-phi. I think it would be theta+phi. Please explain?

[@enriqueh8847]

Is it possible to do one example numerical calculation? Thank you very much.

[@VinodPrajapati-sb4ho]

Sir please explain this Schneider micom relay P122,P222 etc

[@jorgeamado9539]

Please can you explain how should we configurated the characteristic angle for numerical relays

[@rasersk1691]

Sin to cos conversion at 5:28 is wrong, ig. Could you please explain, maybe my math is wrong. Dunno.

[@Mtenesac]

Why the angle between the vref and the flux v is not 90 degrees, i have seen many text that stated that, by the way thank you very much for the content i am studying this at my university and i am a little bit struggling haha

[@yuvvraaj4590]

Please can you explain how to size EDG in oil & gas industry

[@electricaltechnologyandind5335]

I understand edg stands for emergency dg....

[@yuvvraaj4590]

Yes

[@vipulkamdar7834]

Good explanation sir. But why the EF direction is minus in its setting?

[@GauravGupta-pb8mk]

Thank you sir

[@md.shekhfarid6424]

Super

[@abtech2478]

sir your blog is not updated. Its better if there will be some notes on each lecture. Also how, much is approximate earning from the Blogspot?

[@shihabahmed1457]

Thanks

[@satya7077]

Good explanation sir.... Please tell how the principle applied in microprocessor based Modern relays... Waiting for a New video...

[@rimonalhelal3630]

❤🇧🇩

[@velusamypothiraj2300]

You have define with examples

[@electricaltechnologyandind5335]

In my next video i will explain how exactly the direction is measured...

[@do_not_reply4784]

maha vahiyaaaat explanation

[@MrAshwanisaini]

Thank you sir