Electrohome G07 13" Arcade Monitor Problem

Here's a detailed description of what happened to get me here: forum.arcadecontrols.com/index...
This is what the tube looked like when I turned it on a few times after I saw the spark in the neck of the tube. Now there is no more orange glow in the neck, but closer to the neckboard there is a fainter white or blue glow. If you listen you can hear the humming it makes. After the red sort of flash on the screen, there is a circle of blurry colored light taking up most of the screen.

[@ShawnDowler]

There's a lot more detail in the link I added in the description. I have a new flyback on its way. I'll report back here if that fixed anything. Thanks for taking the time to look at this and respond.

[@ShawnDowler]

I just replaced the flyback, the HOT and the regulator. No change. I now notice a smell coming from the monitor while it's on that I didn't notice before. The fuses are good. I'm really having trouble finding anyone with a similar problem. Is there anything else I could check? I really want to fix this. Even if I could get a replacement monitor, I want to fix this one.

[@ShawnDowler]

I already did replace the flyback and the caps. Everything was awesome, but the width was too narrow by about 1 inch on either side. I tried modifying the width using the instructions on Bob Robert's site. That blew the fuse, so I put it back the way it was and now this. Are you saying that I killed the new flyback? I hadn't considered that a possibility, but it does sound about right. I'll replace the flyback and see if that helps. Thanks!

[@arcadeattic]

What were you doing when it blew a fuse were you adjusting the vertical or horizontal to widen it out could of shorted ot if you were using a metel tip flathead screwdriver u should use a small peice of plastic somthing not metel replace fuse and adjust it again with somthing not conductive good luck

[@arcadeattic]

Flyback and cap kit 30 dollar fix