ELIMINATE FAILED 3D Prints with This QUICK FIX!

[@Nukle0n]

I would say you should also look at your bed though. The print head should not be able to shift your magnetic steel sheet like that, normally it's virtually impossible to move the sheet horizontally when its held by the magnetic substrate, that's why you have to pull up at a corner to get it to release.

[@EngineersGrow]

Agree. The bed is on my upgrade list. During the build I did realize the magnets were were weak, but this showed just how weak they are.

[@oOWaschBaerOo]

ok without having seen the video, stopped at where you say the fan is barely noticable, im gonna make a wild guess and say: 24v fan ( or any voltage higher than the port supplies) on a port that does not supply 24v but less, ima edit after the video if i was right :D edit: i was wrong :D but i had 2 friends already complain that theirs had similar issues and they put a 24v fan on a 12v fan after replacing the cooling fan with ones they found recommended for that size, not knowing its different voltages

[@EngineersGrow]

Good point! It's important to double check the fan voltages.

[@Armada2010]

Что же за мусор этот BLV.... Проект прекрасный, исполнение и компоненты.... 🥴