Ender 3 Pro X Voron Switchwire mod update motor XZ Stepperonline

[@IAmTheCraftsman]

Did you design the vertical back pieces where your power cord plugs in? I looked at the original build on thingi and didn’t see print files for any vertical back pieces. Very nice build by the way!

[@sanketss84]

Is the stealth burner head too heavy for the Switchwire ?? How has been your experience so far with it.

[@Joelmoliveira]

What fans are you using? For hotend, part fan, mainboard and PSU. I assume all were changed, because the printer is very silent. Great job ;)

[@simrtech3d]

hotend : Sunon Maglev MF40102V2-A99. Part fan : Hk Fan 5015 or GDS Fan or Sunon Maglev MF50151VX-A99 on the video it's a GDS Fan, but it depends on what I have in stock, anyway a 5015 sounds loud, but I find the most effective the hk fan (personal, others prefer the gds) the Sunon is good obviously, but much more expensive PSU ender 3 : Sunon Maglev MF60152V2-A99 Mainboard electronic : Sunon Maglev MF60152V2-A99 (I don't remember if for this one I reduced the power)

[@Joelmoliveira]

@@simrtech3d thanks. Going to take a look.

[@madorax251]

are you using a y plate BLV? can the right and left rear decks be fitted with a stock y steper motor mount? i'm planning to convert an ender 3 v2 by chance I'm currently using a BLV kit on an ender 3 v2

[@simrtech3d]

I don't understand your question, yes it's a blv kit with the original steper motor mount if that's what you want to know if you want to do the Voron Switchwire mod, I advise you to do only the XZ axis, the y axis can remain that of the blv, it works fine, no need to modify it

[@lanypuspasari1868]

@@simrtech3d I mean are you using Y plate carriage BLV?

[@simrtech3d]

@@lanypuspasari1868 yes it is visible with its cyan blue under the bed : live.staticflickr.com/65535/52083182021_e7dac0f763_c.jpg www.lesimprimantes3d.fr/forum/topic/48110-ender-3-pro-passage-en-switchwire/?do=findComment&comment=499743 before I had the mod blv

[@mitsubishimakes]

Hello, how much did this modification cost?

[@madorax251]

can you give a link to the seller of the stepper motor like the seller you use?

[@antallaczko8793]

You can go ahead with the 40mm smaller ones as per specs, but I'm using these ones. More torque, less heat, no missed steps

[@anhtai_8828]

what do you use to raise the z . axis?

[@simrtech3d]

i use Voron Switchwire XZ Gantry

[@anhtai_8828]

@@simrtech3d where can i get it?

[@rickverhoeven1064]

@@anhtai_8828 you build it yourself with the voron switchwire guide or the ender 3 to switchwire guide

[@kitchenbriks3685]

My direct drive ender 3 prints twice as fast as this. What is the point?

[@simrtech3d]

this video shows an ender 3 pro which is switched to switchwire and it still had to be adjusted, I don't see why you are talking about speed?