Ep. 19: 1988 Ford F250 4x4 Dream Truck MegaSquirt ECU Swap Part 1

[@AlotofVowels]

Yeah it’s just hot glue and solder. If you want this connection to be cleaner I would work on the wire side before cutting the enclosure again and not worry about the “front nut” methodology. Adding a nut could increase the air gap on the connector side and make for a bad contact.

[@AlotofVowels]

The polish on your videos is getting better! You definitely seem more confident in front of the camera. I didn’t pay enough attention but the port you cut a slot for; could you not just disconnect/desolder the wire and just drill a hole in the enclosure without having to cut it altogether?